368111
11
Zoom out
Zoom in
Previous page
1/16
Next page
8
®
Millenia series Portable Evaporative Cooler
3.6 Fan/pump not running
fast enough on low speed.
3.7 Pump drive belt faulty
or broken.
3.6.1 Check that supply voltage is up to correct level.
3.6.2 Fan and pump will pick up speed slightly as the motor
reaches normal operating temperature. Allow the cooler to
run for 30-60 minutes and check again. If there is no
improvement have the cooler checked by a service agent.
3.7.1 Replace drive belt as shown on page 7.
4.1 Reservoir or Aspen
cooling pad dirty.
4.2 Water quality is poor.
4.1.1 Drain reservoir and fill the cooler with clean water. If it
still smells clean the reservoir and replace the Aspen cooling
pad or proceed to 4.2.1.
4.2.1 Add a little vanilla essence or perfume to the water.
4. Cooler makes bad
smell.
5.1 Dirt has accumulated
inside pump.
5.1.1 Proceed as in 3.5.1
5.1.2 Replace drive belt as shown on page 7.
5. Cooler makes
scraping or rattling
noise on new season
start up.
6.1 Too much water in
reservoir.
6.2 Water level indicator
not working.
6.1.1 Drain some water out (see page 7).
6.2.1 Remove the rear panel for access. Slide the indicator
up to the 'FULL' position then let it drop. If it fails to operate
have it checked by a service agent.
6. Water overflows from
reservoir.
7.1 Electrical fault.
7.1.1 Electrical parts must only be repaired and replaced by
Authorised Service Agents.
7. Cooler will not
operate at all.
8.1.1 If the power supply cord of this appliance is damaged it
must be replaced. Electrical parts must only be repaired and
replaced by Authorised Service Agents.
8. Damaged power
supply cord.
3. No cooling.
3.1 Cooling control is off.
3.2 Reservoir is empty or
nearly empty.
3.3 Weather is too humid.
3.4 Aspen cooling pad and
/ or pump inlet screen
blocked or dirty.
3.5 Pump is not working
properly.
3.1.1 Turn cool knob to 'COOL'.
3.2.1 Fill with water again until water level indicator is at the
'FULL' position. Water capacity is 14 litres
3.3.1 Turn cool knob to '0' and use cooler as a fan only.
3.4.1 Clean parts - see maintenance page 6.
3.5.1 The pump is NOT a separate electric pump. It is
connected to the fan motor and is driven mechanically. Turn
the cooler off and completely drain the reservoir. Refill with
water. Switch fan knob to high speed (3), turn the cool knob
to 'COOL',run the cooler for 10-15 minutes non-stop. This will
help dissolve and flush out the dirt. The Aspen cooling pad
should now be wet. If the pad is not visibly wet and there is
no cooling, have the cooler checked by a service agent.
1. Cooler will not
operate at first.
2. Cooler stops
operating after running
for some time.
1.1 Power outlet or supply
faulty.
1.2 Wrong voltage.
2.1 Motor overheated
(safety cutout).
1.1.1 Switch on power outlet.
1.1.2 Check power supply.
1.1.3 Check power outlet.
1.2.1 Check that power supply is the same as specified on
the rating label.
2.1.1 Wait 30-45 minutes for motor to cool down and it will
restart automatically. If condition persists take the cooler to a
service agent.
TROUBLESHOOTING
CONDITION POSSIBLE CAUSE REMEDY
9SEELEY INTERNATIONAL OWNERS MANUAL
When ordering spare parts, please specify the model / serial number
and colour of your cooler.
SPARE PARTS LIST
Item Description
1 Tank (includes drain plug)
2 Drain Plug
3 Rear Panel
4 Filter Pad
5 Front Grille Assembly
6 Badge - Front Grille
7 Window
8 Filler Door
9 Mid Panel Assembly
10 Inner Grille / Spreader Assembly
11 Inner Grille Door
12 Screws
13 Front / Rear Pillar (pair)
14 Base
14.1 Base - compact
15 Castor & Pintle Assembly
16 Control Panel
17 Control Box
18
18.1
Knob Mushroom
Knob Mushroom & Shaft Assembly
19 Water Valve Assembly
20
20.1
Switch (2006 - ) Millenia / Mastercool
Switch (2006 - ) Megacool
22 Lever Vane
23 Vane Link RH
24 Vane Link LH
25 Vane
26 Vane Bearing
27 Vane Link Motor
(Millenia / Megacool)
(Millenia / Megacool only)
(Mastercool only)
Item Description
28 Pad Clamp
29 Water Level Indicator
30 Float Assembly
31 Pump Assembly
32 Strainer
33 Vane Motor
34 Vane Motor Hub
36 Fan Pulley
37 Fan
38 Drive Belt
39
Spreader Hose
Æ
9.5 x 450
41
Pump Hose
Æ
9.5 x 890
42
42.1
Motor Rubbers White for Square Motor
Motor Rubbers Black for Round Motor
43.1
43
Electric Motor 230V 50Hz - Round
Electric Motor 230V 50Hz - Square
44
Capacitor 3.2uf for Motor
46
Plug & Cord Australia
47
Cord Grip - Flat Cord 4K-1
(Megacool only)
(Megacool only)
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Convair koeler mastercool at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Convair koeler mastercool in the language / languages: English as an attachment in your email.

The manual is 1,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info