334791
8
Zoom out
Zoom in
Previous page
1/86
Next page
Gas burners
Each control knob indicates which burner it controls.
To light a burner, push in the knob for the burner you
wish to use and turn it in an anti-clockwise direction to
the lighting position. Hold the knob at the maximum
position for a few seconds until the burner ignites and
then release and set the knob to the desired setting. If
the burner does not light at the first attempt, repeat the
operation.
If the spark plugs are dirty, then a fault may occur in the
ignition system. Keep them completely clean. Clean the
spark plugs using a small brush, remembering that the
plugs must not receive any kind of violent impact.
To turn the burners off, turn the control knob in a
Your modern functional hob is equipped with progressive
valves which permit you to find the perfect flame setting
between maximum and minimum.
Depending on the model that you have purchased, your
hob may come with a triple-flame burner, the perfect
system for cooking paellas, using woks, etc.
Gas appliances create both heat and humidity in the
room they are used in. Make sure that your kitchen is
properly ventilated: keep natural ventilation outlets open
or install a mechanical ventilation system (extractor fan).
When using your appliance for a prolonged period of
time, it may be necessary to provide additional ventilation
e.g. by opening a window (without creating a draught)
or turning up the setting on your mechanical ventilation
system.
Fig. 1.
(Fig. 1.)
clockwise direction to the
setting.
6
If the burner goes out (e.g. a draught) when in use, the
If this ignition is unsuccessful (e.g. as a result of boiled-over
control knob to and check whether the cause can be
Every hotplate features a safety pilot!
This means that if the flame ever goes out (e.g. is
extinguished by boiled-over liquid), the flow of gas is
appliance will switch the hotplate on again automatically.
interrupted.
interrupted and an acoustic signal is emitted. Turn the
The safety system will indicate any anomalies in its
rectified using the table on page 11.
working through acoustic signals (see "Home
troubleshooting" section).
liquid on the burner), the flow of gas to this burner is
The appliance switches off automatically after 6 hours
of operation. Turn all the control knobs to the position
and then you can turn the appliance on again.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Constructa cm 17451 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Constructa cm 17451 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 7,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info