Installation and connection en
35
Removing the appliance
Also observe
the sequence of worksteps here.
1. Disconnect the appliance from
the power supply.
2. Turn off the water supply.
3. Undo the waste water and drinking
water connection.
4. Loosen fastening screws for
the furniture parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully
pulling the hose behind.
Transportation
Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
1. Turn on the tap.
2. Open the door.
3. Switch on ON/OFF switch (.
4. Select programme @ with
the highest temperature button <
H.
5. Press START button h.
6. Close the door.
Programme sequence starts.
7. Open door after approx. 4 minutes.
8. Press START button h
for approx. 3 sec.
The Cleaning display X goes out.
9. Close the door.
The remaining programme sequence
lasts approx. 1 minute more. (Buzzer
sounds.)
10.Switch off ON/OFF switch (.
11.Turn off the tap, disconnect supply
hose and drain water.
Transport appliance upright only.
(This prevents residual water from
running into the machine control
and damaging the programme
sequence.)
