Manual Constructa CD30676 (page 23 of 56) (English, German, Dutch, French)

715186

Zoom out

Zoom in

1/56

: Important safety information

Read these instructions carefully. Only then

will you be able to operate your appliance

safely and correctly. Retain the instruction

manual and installation instructions for

future use or for subsequent owners.

The appliance can only be used safely if it

is correctly installed according to the safety

instructions. The installer is responsible for

ensuring that the appliance works perfectly

at its installation location.

The width of the extractor hood must

correspond at least with the width of the

hob.

For the installation, observe the currently

valid building regulations and the

regulations of the local electricity and gas

suppliers.

When conveying the exhaust air, official and

legal regulations (e.g. state building

regulations) must be followed.

Risk of death!

Risk of poisoning from flue gases that are

drawn back in. The exhaust air must not be

conveyed into a functioning smoke or

exhaust gas flue or into a shaft which is

used to ventilate installation rooms that

contain heating appliances. If the exhaust

air is to be conveyed into a non-functioning

smoke or exhaust gas flue, you must obtain

the consent of the heating engineer

responsible.

Danger of death!

Risk of poisoning from flue gases that are

drawn back in.

Always ensure adequate fresh air in the

room if the appliance is being operated in

exhaust air mode at the same time as room

air-dependent heat-producing appliance is

being operated.

Room air-dependent heat-producing

appliances (e.g. gas, oil, wood or coal-

operated heaters, continuous flow heaters

or water heaters) obtain combustion air

from the room in which they are installed

and discharge the exhaust gases into the

open air through an exhaust gas system

(e.g. a chimney).

In combination with an activated vapour

extractor hood, room air is extracted from

the kitchen and neighbouring rooms - a

partial vacuum is produced if not enough

fresh air is supplied. Toxic gases from the

chimney or the extraction shaft are sucked

back into the living space.

■

Adequate incoming air must therefore

always be ensured.

■

An incoming/exhaust air wall box alone

will not ensure compliance with the limit.

Safe operation is possible only when the

partial vacuum in the place where the heat-

producing appliance is installed does not

exceed 4 Pa (0.04 mbar). This can be

achieved when the air needed for

combustion is able to enter through

openings that cannot be sealed, for

example in doors, windows, incoming/

exhaust air wall boxes or by other technical

means.

In any case, consult your responsible

Master Chimney Sweep. He is able to

assess the house's entire ventilation setup

and will suggest the suitable ventilation

measures to you.

Unrestricted operation is possible if the

vapour extractor hood is operated

exclusively in the circulating-air mode.

Danger of death!

Risk of poisoning from flue gases that are

drawn back in. If installing a ventilation

system in a room with a heat-producing

appliance connected to a chimney/flue, the

electricity supply to the hood must be

equipped with a suitable safety switch.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Constructa CD30676 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Constructa CD30676 Manual

Product: