Manual Conrad 856340 (page 28 of 76) (English, German, Dutch, French)

630109

Zoom out

Zoom in

1/76



Before drilling holes in your vehicle, make sure that

• the electrical equipment is not damaged

• the function of your vehicle is not negatively effected

• the operating licence does not lapse

• the fuel tank is not damaged

• your vehicle’s safety or function is not impaired in any way.

If you are not sure whether the designated drill holes meet the crite-

ria mentioned above, consult a qualified automotive electrician. It is

advisable to have a qualified automotive electrician carry out the

installation and the connection.

- Hold the camera mount against the designated mounting spot.

- Mark the drill holes.

- Make 6 holes in the number plate holder: One drill hole as a cable feedthrough

and five holes for the camera mount. The cable feedthrough should be close to

the camera’s power cables.

Put the camera’s power cable through the (provided) rubber grommet. The rub-

ber grommet protects the cable from sharp edges or damage.

- Run the cables through the drilled cable feedthrough.

- Attach the rubber grommet to the drill hole of the cable feedthrough.

- Lay the cables to the designated back-up light or rear light. Make sure that the

cable is not obstructed or entangled.

- Remove the light holder from the back-up light housing. Remove the light bulb to

protect it from damage.

- Attach the aerial to the camera.

Install the camera mount with the camera at the installation place using suit-

able mounting material. Make sure that no cables are squeezed or damaged

otherwise.

- Adjust the camera to the desired position.

- Tighten the fixing screws of the camera mount to make sure the camera is tight-

ly installed.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Conrad 856340 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Conrad 856340 Manual

Product: