552575

Conrad 610630 Manual

37
Zoom out
Zoom in
Previous page
1/104
Next page
37
Heating operation
In heating operation, the relay is switched when the temperature drops below the set value,
so that the contacts “COM” and “NO” are connected. A connected heater must switch on now.
When the temperature measured via the sensor exceeds the set threshold value, the relay
switches off so that the contacts “COM” and “NC” are connected. The connected heater now
has to switch off.
Cooling operation
In cooling operation, the relay is switched when the temperature exceeds a set value, so that
the contacts “COM” and “NO” are connected. A connected cooler must switch on now.
When the temperature measured via the sensor undercuts the set threshold value, the relay
switches off so that the contacts “COM” and “NC” are connected. The connected cooler now
has to switch off.
• First set the room temperature controller on the left screw with the left attachment hole (8)
and push it a bit to the left.
The room temperature controller is fastened to the screw by this.
Observe that the cables connected to the terminal clamps are not crushed or damaged by
sharp edges.
When the room temperature controller cannot be pushed open beyond the oblong
hole of the left attachment hole (8), turn out the screw a bit.
If the room temperature controller is too loose, however, turn the screw in a bit further.
• Then screw the room temperature controller in tight through the second attachment hole (7)
in the battery compartment bottom (6).
Check if the room temperature controller is attached firmly to both screws.
• Switch on the mains voltage.
• If you have not done so yet, insert two type AA/mignon batteries in the battery compartment
(6) with the correct polarity; see Chapter 10.
… 37 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Conrad 610630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Conrad 610630 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info