675127
34
Zoom out
Zoom in
Previous page
1/96
Next page
34
10. Installation
Caution, important!
Observe Chapter „5. Safety Notes“ and „9. Preparations for Installation“!
Open the casing by first unscrewing the single screw (1) on the right side. Then carefully
fold apart the two casing halves by about 45° until the upper part of the casing can be
lifted off.
Remove the screw (2) for the protective cover (3) and carefully remove the protective
cover.
Use the fastening apertures (4) to screw the room thermostat to the wall. Guide the
connection cable through the aperture (5).
Use appropriate screws and dowels according to the surface. When drilling or tightening
screws, ensure that no wires or lines are damaged.
Connect the power supply to the screw
terminals (6). The relay is potential-free.
NC = Opener contact (NC = „normally
closed“ = The contact is closed
when not activated)
NO = Closer contact (NO = „normally
open“ = The contact is open when
not activated)
COM = Centre contact
Replace the protective cover (3) again and secure it with the screw (2).
The room thermostat must only be operated with the correctly attached and
screwed-on protective cover.
If the protective cover is missing or wrongly installed, there is a danger to life from
electrical shock during battery replacement!
If you have not done so yet, insert two type AA/mignon batteries in the battery
compartment (7) with the correct polarity; see Chapter 8.
Close the casing by placing the upper part with the catches (8) on the two corresponding
openings in the lower casing part at an angle of about 45° and then closing the upper part
of the casing. Retighten the screw (1) turned out in the beginning. The room thermostat
is now ready for operation.
NC
NO
COM
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Conrad 610578 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Conrad 610578 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info