652338
68
Zoom out
Zoom in
Previous page
1/80
Next page
68 Maintenance
6.8 Performingsoftwareandrmwareupdates
To update the control software or the driver board rmware, proceed as follows:
1. Set the On/Off switch on the front side of the steam humidier to the Off position, then switch off the
voltage supply to the steam humidier via the external disconnect switch (electrical isolator) and
secure switch in the off position to prevent it from inadvertent power up.
2. Unlock the door panel on the control compartment side of the steam humidier and remove it.
3. Swing control panel assembly open.
4. Carefully insert FAT32 formatted USB memory stick containing the software updates into the USB
port on the control board. Make sure that the maximum length of the memory stick does exceed 75
mm.
Note: in order to update the control software or the rmware of the driver board a USB stick with a
valid software update (the update les must be on the highest level outside of any folder) must be
connected to the USB port on the control board. Otherwise, an appropriate fault message appears
when starting the software update.
5. Close control panel assembly, then close the door panel of the control compartment and lock it with
the screw.
6. Remove the lock and tag from the external disconnect switch. Then, switch on external disconnect
switch to restore power to the humidier.
7. Set the On/Off switch on the front side of the steam humidier to the On position.
8. When the standard operating display appears, select the <Menu> button, then enter the password
(8808) to login.
9. Select "Administrator > Software Update tab", then select the desired update function:
select "Software Update" to update the control software,
select "Driver A.DB.A" update the rmware for the driver board of Module A
select "Driver B.DB.B" update the rmware for the driver board of Module B (on double unit or
large units with two steam cylinders),
select "Driver C.DB.A" update the rmware for the driver board of optional Condair RO-A reverse
osmosis system (only possible, if Condair RS is congured for the operation with a Condair RO-A
reverse osmosis system).
The update starts. A progress bar is shown in the display. If the update has completed the control
unit returns to the standard operating display.
CAUTION!
Do not interrupt a software or rmware update once it has started. Wait until updating is completed.
Corrupted control software or rmware can render the humidier unusable.
Note: If software update is accidentally interrupted, the humidier will not operate, but the software
update can be resumed by leaving the USB key inserted in the control board and power cycling
the unit. The integrated controller will detect the software was not properly installed, and restart
the update.
10. Repeat steps 1 to 3, then carefully remove the USB memory stick.
11. Close control panel assembly, then close the door panel of the control compartment and lock it with
the screw.
12. Repeat Step 6 and 7 to power up the humidier.
68


Need help? Post your question in this forum.

Forumrules
1

Forum

condair-rs

Reset search

  • why drain hose led to left, is it due to electrical on right side.
    Submitted on 29-8-2022 at 23:32

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Condair RS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Condair RS in the language / languages: English as an attachment in your email.

The manual is 5,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Condair RS

Condair RS Installation Guide - English - 80 pages

Condair RS User Manual - Dutch - 80 pages

Condair RS Installation Guide - Dutch - 76 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info