153
Solution
Rotate the function dial to and slide the power
switch to turn on the camera.
Replace all four batteries or use the AC adapter
( sold separately ).
Remove the batteries and then insert the batteries by
following the +/- diagram indicated in front of the bat-
tery-chamber door.
When "NO CARD" is displayed on the LCD monitor and
"CF" is displayed on the data panel, the CF card is not
set. Insert the CF card.
Slide the power switch to turn on the camera again.
The camera reads out the image data from the CF
card.
Wait until the reading is completed and the focus lamp
and "PLAY BACK" stop blinking.
Take a picture within the flash range ( 0.4 to 3 m ) .
Problem
The image
cannot be
played
back on
the LCD
monitor.
Theimage
recorded in
the flash
mode is
dark.
Check
Is the power of the camera
turned off?
Are the batteries exhausted?
Are the batteries inserted with the
correct polarity?
Is the CF card is inserted in the
camera? ( Is "NO CARD" dis-
played on the LCD monitor? )
The auto power off function acti-
vates.
Is the focus lamp ( green )
blinks slowly (about 2 times in
a second ) and "PLAY BACK"
blinks on the LCD monitor?
Did you take a picture within
the flash range?
Page
80
25
28
25
25
29
44