520078

Concept2 Model E Manual

28
Zoom out
Zoom in
Previous page
1/36
Next page
28
MANTENIMIENTO
Cronograma de
Mantenimiento
Recomendado
Diariamente:
Limpie el monorriel con un trapo o una esponia de
limpiezanoabrasiva,despuésdeusarlo.Consulte
la página 30.
Cada 50 horas de uso
(semanalmente para los usuarios
institucionales):
Limpie y lubrique la cadena con el aceite
suministrado (o Aceite de Motor 20W o aceite 20W
3en1).Consultelapágina31.
Cada 250 horas de uso (mensualmente
para usuarios institucionales):
1) Inspeccionelacadena,buscandoeslabones
trabados. Si una lubricación a fondo no mejora la
situación,deberáreponerselacadena.
2) Inspeccioneelconectorentrelacadenayel
eslabón giratorio para determinar si está
desgastada.Sielagujerosehaensanchado,osi
elpernoenUestádesgastadoporlamitad,se
deberá reemplazar toda la conexión.
3) Aprietelagomasilaempuñaduranovuelve
completamente al protector del ventilador.
Consulte la página 32.
4) Reviselostornillosdelaveallenusadospara
instalarlapatadelantera,cerciorándosedeque
estén apretados.
5) Suelteoaprietelastuercasdelasunionesdel
brazodelMonitordeRendimiento,comosea
necesario.
6) Revisedentrodelaruedavolante,conunfoco
(linterna),paradeterminarsihaypolvodentro.
Aspírelo,desernecesario.Consultelapágina34.
IMPORTANTE: El monitor es una unidad
sellada. NO lo abra. Cualquier intento
de abrirlo anulará la garantía. Póngase
en contacto con Concept2 en caso de
tener problemas con esta parte.
MANUTENZIONE
Programma di
Manutenzione
Raccomandato
Ogni giorno:
Dopol’uso,pulirelamonorotaiaconunpannooun
tampone pulente non abrasivo. Vedere pagina 30.
Dopo ogni 50 ore di uso
(settimanalmente, se usato in palestre,
ecc.):
Pulire e lubrificare la catena con l’olio fornito in
dotazione (oppure con olio da motori 20w o olio
20w3-in-1).Vederepagina31.
Dopo ogni 250 ore di uso (mensilmente,
se usato in palestre, ecc.):
1) Ispezionarelacatenaperrilevarel’eventuale
presenza di maglie indurite. Se la completa
lubrificazionenoneliminailproblema,sostituire
la catena.
2) Controllareseilcollegamentocatena-manicoè
consumato.Seilforosièallungato,olastaffaa
Uèpermetàlogorata,sostituirel’intero
collegamento.
3) Stringereilcavoelasticoammortizzatoreseil
manico non ritorna completamente dentro lo
scomparto del ventilatore. Vedere pagina 32.
4) Controllarechelevitiadesagonoincassato,
usateperinstallareilpiedeanteriore,sianoben
strette.
5) Allentareostringereidadisullearticolazionidel
braccio del Monitor delle prestazioni.
6) Controllareconunapilasedellapolvereè
presenteall’internodelvolano.Senecessario,
rimuovere la polvere con un aspiratore. Vedere
pagina 34.
IMPORTANTE: Il monitor è una unità
sigillata. NON aprire. Se le unità
vengono aperte, la garanzia diventa
nulla. Per problemi su questa parte,
rivolgersi alla Concept2.
MANUTENÇÃO
Tabela de Manutenção
Sugerida
Diariamente:
Limpe o monocarril com um pano ou esponja não
abrasiva após cada utilização. Consulte a página 30.
De 50 em 50 horas de uso
(semanalmente para utilização em
instituições)
Limpe e lubrifique a corrente com o óleo fornecido
(ouóleodemotor20wouóleodeusogeral20w):
Consulte a página 31.
Após 250 horas de uso (mensalmente
para utilização em instituições)
1) Inspeccioneacorrenteparaidentificarelospresos.
Sealubrificaçãocompletanãoresolver,acorrente
deve ser reposta.
2) Inspeccioneaconexãoentreomanípuloea
corrente para identificar desgaste. se o furo for
alongado,ouseacavilha-Uestivergastapela
metade,todaaconexãodeveserreposta.
3) Ajusteacordadechoquenocasodomanípulo
não voltar totalmente até a capa de proteção da
ventoinha. Consulte a página 32.
4) Verifiqueajustezadosparafusossextavados
interiores que seguram o pé anterior.
5) Apertarousoltarasporcasnasarticulaçõesdas
alavancas do Monitor de Desempenho.
6) Inspeccioneointeriordovolantecompilhae
removapoeiracomumaspirador,casonecessário.
Consulte a página 34.
IMPORTANTE: O monitor é uma
unidades seladas. NÃO o desmonte.
Qualquer tentativa de desmontá-lo
invalidará a garantia. Consulte a
Concept2 sobre problemas com esta
unidade.
MAINTENANCE
Recommended
Maintenance Schedule
Daily:
Wipe monorail with a cloth or non-abrasive scouring
pad after use. See page 30.
Every 50 hours of use
(weekly for institutional users):
Clean and lubricate the chain with the oil provided
(or20wMotorOilor20w3-in-1oil).Seepage31.
Every 250 hours of use
(monthly for institutional users):
1)Inspectchainforstifflinks.Ifthoroughlubrication
doesnothelp,thechainshouldbereplaced.
2)Inspectchain-handleconnectionforwear.Ifthe
holehasbecomeelongated,ortheU-boltisworn
halfwaythrough,theentireconnectionshouldbe
replaced.
3)Tightentheshockcordifthehandledoesnot
return all the way to the fan enclosure. See page
32.
4)Checkthesocketscrewsusedtoinstallthefront
leg for tightness.
5)LoosenortightenthenutsonthePerformance
Monitor arm joints as necessary.
6)Checkfordustinsideflywheelwithflashlight.
Vacuum if needed. See page 34.
IMPORTANT: The monitor is a sealed
unit. Do not take apart. Any attempt to
disassemble will void warranty. Contact
Concept2 for problems with this part.
ENTRETIEN
Programme d’Entretien
Suggéré
Quotidien:
Essuyer le monorail avec un chiffon ou un tampon
de nettoyage non abrasif après utilisation. Voir la
page 30.
Toutes les 50 heures d’utilisation (à
effectuer toutes les semaines pour les
utilisations en institution) :
Nettoyer et lubrifier la chaîne avec l’huile fournie (ou
del’huiledemoteur20Woudel’huile20W3-en-1).
Voir la page 31.
Toutes les 250 heures d’utilisation (à
effectuer tous les mois pour les
utilisations en institution)
1)Inspecterlachaînepourvérifiers’ilyades
maillons raides. Si une lubrification complète
n’aidepas,lachaînedevraêtreremplacée.
2)Inspecterlaconnexiondelachaîneetdelapoi-
gnéepourl’usure.Siletrous’estagrandi,ousile
boulonenUestusédemoitié,toutela
connexion doit être remplacée.
3)Serrerlacordeélastiquesilapoignéenerevient
pas complètement vers le boîtier du ventilateur.
Voir la page 32.
4)Vérifierquelesvisàtêtecylindriqueutilisées
pour monter le pied avant sont bien serrées.
5)Desserrerouserrerlesboulonssurlesjointsdu
bras de l’Ordinateur de bord selon les besoins.
6)Al’aided’unelampedepoche,vérifiers’ilyade
la poussière à l’intérieur de la roue libre. Nettoyer
à l’aspirateur si nécessaire. Voir la page 34.
IMPORTANT: L’ordinateur de bord est
un élément scellé. NE PAS le démonter.
Toute tentative de démontage annulera
la garantie. Contacter Concept2 en cas
de problème avec cette pièce.
WARTUNG
Empfohlener Wartungsplan
Täglich:
Wischen Sie die Schiene nach Gebrauch mit einem
Lappen oder weichem Schwamm ab. Siehe Seite 30.
Nach 50 Stunden Gebrauch (wöchentlich
für Gewerbliche Benutzer):
Reinigen und schmieren Sie die Kette mit dem
beiliegendenÖl,(oder20WMotorenöloder20W
Mehrzwecköl).SieheSeite31.
Nach 250 Stunden Gebrauch
(monatlich für institutionelle Benutzer):
1)InspizierenSiedieKetteauffestsitzende
Kettenglieder.FallsgründlichesSchmierennichthilft,
sollte die Kette ersetzt werden.
2)InspizierenSiedieKette-GriffVerbindungauf
Abnutzung. Falls sich das Loch verlängert hat oder
derU-Bolzenhalbdurchscheuertist,solltedieganze
Verbindung erneuert werden.
3)ZiehenSiedieRückführschnurfester,wennderGriff
nicht ganz bis zum Ventilatorgehäuse zurückgeführt
wird. Siehe Seite 32.
4)ÜberprüfenSie,daßsichdiebeiderInstallationdes
Vorderbeins verwendeten Innensechskantschrauben
nicht gelöst haben.
5)Wennnotwendig,könnenSiedieMutternanden
Gelenken des Leistungsmonitorarms lösen oder fes-
tziehen.
6)MiteinerTaschenlampeuntersuchenSiedasInnere
des Schwungradgehäuses auf Staub. Wenn notwen-
dig,saugenSiedenStaubab.SieheSeite34.
WICHTIG: Der Monitor ist eine versiegelte
Einheit. Nehmen Sie diese NICHT aus-
einander. Jeder Versuch diese Einheit
auseinanderzunehmen, wird die Garantie
ungültig machen. Sollten Sie mit diesem
Teil Probleme haben, wenden Sie sich an
Concept2.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Concept2 Model E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Concept2 Model E in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 8,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info