670189
8
Zoom out
Zoom in
Previous page
1/12
Next page
CONCEPT2.COM
Page 8 0819
Assembly continued
CONCEPT2 DYNAMIC INDOOR ROWER
At the opposite end of the machine where the
shuttle channel meets the rear leg, reach into the
slot in the shuttle channel and grasp the shuttle.
Pull the shuttle up through the slot in the shuttle
channel so that it is exposed. See photo U.
Push the looped end of the handle drive cord up
through the shuttle (between the two pulleys) and
over the handle drive cord pulley. See photo V.
Pull the handle drive cord toward the front leg
assembly so that all the slack is taken up around
the drive cord pulley. See photo W.
Slide the foot carriage all the way to the end of
the rail near the front leg assembly. Hook the
looped end of the handle drive cord over the
exposed tip of the drive plate hook. See photo X.
Tuck the handle drive cord down into the slot in
the shuttle channel so that the knot of the looped
end is inside the shuttle channel and behind the
drive plate hook. Pull back on the handle drive
cord to ensure that the loop is fully seated at the
base of the drive plate hook. Check the knot to
ensure it is not rubbing against the top of the
shuttle channel. If it is rubbing, remove the loop
from the drive plate hook and rotate it so that the
tail of the knot is pointing down and away from
the top of the shuttle channel.
See photo Y.
photo U
photo X
photo W
photo V
Handle
Drive Cord
Pulley
photo Y
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Concept2 Dynamic Indoor Rower at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Concept2 Dynamic Indoor Rower in the language / languages: English as an attachment in your email.

The manual is 5,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Concept2 Dynamic Indoor Rower

Concept2 Dynamic Indoor Rower Installation Guide - English - 3 pages

Concept2 Dynamic Indoor Rower User Manual - English - 16 pages

Concept2 Dynamic Indoor Rower User Manual - English - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info