Manual Concept VP4354 (page 20 of 51) (English, German, French, Italian, Polish, Spanish)

802935

Zoom out

Zoom in

1/51

VP4350 | VP4351 | VP4352 | VP4353 | VP4354

OPERATING INSTRUCTIONS

Assembling the vacuum cleaner

NOTICE

Always switch oﬀ the appliance and disconnect the charger from wall socket before assembling or removing accessories!

Accessories

1. Floor nozzle *for VP4353, VP4354 only

2. Slot nozzle

This nozzle is used for vacuuming spaces which are hard to reach, such as radiators, slots, corners, bases, space

between the upholstery, etc.

3. Nozzle with a brush

This nozzle is used for vacuuming furniture, upholstery, books, lamps, etc. *for VP4352, VP4353, VP4354 only

4. PET brush

This brush is used for vacuuming animal fur directly on the animal (cat, dog). *for VP4351, VP4353 and VP4354 only

5. Car nozzle

This nozzle is used for vacuuming spaces in cars which are not easily accessed by vacuum cleaners. *for VP4352,

VP4353, VP4354 only

6. Head for vacuuming water

This head is used for vacuuming a smaller amount of water.

7. Head reducer

It is used to attach the PET brush and Car nozzle to the vacuum cleaner. *for VP4351, VP4352, VP4353 and VP4354 only

8. Bag for accessories *for VP4353, VP4354 only

9. Cleaning brush for cleaning the HEPA ﬁlter *for VP4353, VP4354 only

10. Charger *for VP4353, VP4354 only

11. Charging station *for VP4350, VP4351 and VP4352 only

12. Extension tube 2 pcs *for VP4353, VP4354 only

Charging the battery

To prolong the life of the vacuum cleaner battery, follow these instructions:

• Do not leave the vacuum cleaner fully charged or completely discharged

for a long time.

• Prolonged discharged of the battery will result in loss of its capacity.

• Do not let the vacuum cleaner to be completely discharged.

• It is ideal to keep the capacity of the battery between 20 % - 80 %.

During charging, three LED lights next to the power button ﬂash one by one.

The charging is complete when all three LED lights are continuously on.

Operating time at full charge of the battery is approximately 20 minutes.

Using the vacuum cleaner

NOTE

Before using the vacuum cleaner, make sure that the ﬁlters are correctly positioned and ﬁxed.

1. Remove the vacuum cleaner from the charging base. *for VP4350, VP4351 and VP4352 only

2. Press the On/Oﬀ switch to turn on the vacuum cleaner.

3. After you are done using it, press the On/Oﬀ switch again to turn it oﬀ.

Checking the fullness of the dust container

If the suction power of the vacuum cleaner is reduced or the dust container is full, empty it and clean the vacuum cleaner

ﬁlter. For the VP4353 and VP4354, you can use a cleaning brush (K) to clean the ﬁlters.

VP4350 | VP4351 | VP4352 | VP4353 | VP4354 VP4350 | VP4351 | VP4352 | VP4353 | VP4354

OPERATING INSTRUCTIONS

Assembling the vacuum cleaner

NOTICE

Always switch oﬀ the appliance and disconnect the charger from wall socket before assembling or removing accessories!

Accessories

1. Floor nozzle *for VP4353, VP4354 only

2. Slot nozzle

This nozzle is used for vacuuming spaces which are hard to reach, such as radiators, slots, corners, bases, space

between the upholstery, etc.

3. Nozzle with a brush

This nozzle is used for vacuuming furniture, upholstery, books, lamps, etc. *for VP4352, VP4353, VP4354 only

4. PET brush

This brush is used for vacuuming animal fur directly on the animal (cat, dog). *for VP4351, VP4353 and VP4354 only

5. Car nozzle

This nozzle is used for vacuuming spaces in cars which are not easily accessed by vacuum cleaners. *for VP4352,

VP4353, VP4354 only

6. Head for vacuuming water

This head is used for vacuuming a smaller amount of water.

7. Head reducer

It is used to attach the PET brush and Car nozzle to the vacuum cleaner. *for VP4351, VP4352, VP4353 and VP4354 only

8. Bag for accessories *for VP4353, VP4354 only

9. Cleaning brush for cleaning the HEPA ﬁlter *for VP4353, VP4354 only

10. Charger *for VP4353, VP4354 only

11. Charging station *for VP4350, VP4351 and VP4352 only

12. Extension tube 2 pcs *for VP4353, VP4354 only

Charging the battery

To prolong the life of the vacuum cleaner battery, follow these instructions:

• Do not leave the vacuum cleaner fully charged or completely discharged

for a long time.

• Prolonged discharged of the battery will result in loss of its capacity.

• Do not let the vacuum cleaner to be completely discharged.

• It is ideal to keep the capacity of the battery between 20 % - 80 %.

During charging, three LED lights next to the power button ﬂash one by one.

The charging is complete when all three LED lights are continuously on.

Operating time at full charge of the battery is approximately 20 minutes.

Using the vacuum cleaner

NOTE

Before using the vacuum cleaner, make sure that the ﬁlters are correctly positioned and ﬁxed.

1. Remove the vacuum cleaner from the charging base. *for VP4350, VP4351 and VP4352 only

2. Press the On/Oﬀ switch to turn on the vacuum cleaner.

3. After you are done using it, press the On/Oﬀ switch again to turn it oﬀ.

Checking the fullness of the dust container

If the suction power of the vacuum cleaner is reduced or the dust container is full, empty it and clean the vacuum cleaner

ﬁlter. For the VP4353 and VP4354, you can use a cleaning brush (K) to clean the ﬁlters.

Vacuuming water

The vacuum cleaner also allows you to vacuum a small amount of water. It is necessary to attach the head for vacuuming

liquids to the vacuum cleaner. However, the amount of water must not exceed the maximum level of dirt of the dust

container. This may cause clogging of ﬁlters and serious damage to the appliance. Empty the dust container before

vacuuming water. Never leave water in the container.

MAINTENANCE

It is recommended to empty the dust container and clean the vacuum cleaner ﬁlters after each use of the vacuum

cleaner.

Emptying the dust container

1. Disconnect the charger from the mains.

2. Hold the vacuum cleaner down with a dust container.

3. Press the latch to release the dust container.

4. Remove the water separator and empty the vacuum cleaner dust container.

5. Reverse the procedure to attach the water separator and the ﬁlter and put the dust container back.

Cleaning and replacing the permanent ﬁlter

The vacuum cleaner ﬁlter can be cleaned by mechanical tapping and cleaning with a soft brush. Heavily soiled ﬁlter can

be washed after this step and cleaned with a soft brush in lukewarm water without detergents.

It is important to let the wet parts dry thoroughly. A wet ﬁlter would be depleted by vacuuming! Do not use

ahair dryer for drying!

Note: Wet cleaning can cause more wear on the ﬁlter and thereby shortening its life.

• The ﬁlter should be cleaned or replaced with visible soiling or when the suction power of the vacuum cleaner drops.

Check it after each use of the vacuum cleaner.

• To avoid damaging the vacuum cleaner, do not use it without a properly ﬁtted ﬁlter and water separator.

• You can purchase a suitable ﬁlter type from your dealer or order from the manufacturer.

CLEANING AND MAINTENANCE

Accessories and vacuum cleaner can be cleaned with a damp cloth.

Do not immerse the power cord or the charger in water or any other liquid.

Do not use aggressive substances such as solvents or abrasives for cleaning!

TROUBLESHOOTING

Problem Cause Remedy

The motor is not working. The battery is discharged. Charge the battery.

Reduction of suction power.

Full or clogged dust

container. Empty and clean the dust container.

The ﬁlter is clogged. Clean or replace the ﬁlter.

Operating time at full charge is

less than 1 minute. The battery life is over. Replace the battery with a new one.

Contact an authorized service centre.

The vacuum cleaner is warming

up.

Warming up of the vacuum cleaner during operation is normal, it is not

amalfunction.

ENEN

3938 VP4350 | VP4351 | VP4352 | VP4353 | VP4354VP4350 | VP4351 | VP4352 | VP4353 | VP4354

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Concept VP4354 in the language / languages: English, German, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Concept VP4354 Manual

Product: