3.1 Programming steps:
Press the “• SET” button to go back to the main screen.
Press the “• SET” button again and hold it down and press the “PROG”
button, too. At this point the device gets into programming mode and the
numbers indicating the days of the week (1 2 3 4 5 6 7) are flashing on
the display.
Select the day to be programmed or all days of the week by pressing, •
or pressing repeatedly, the large........or........button on the front panel
of the device. If you wish to write the same program for each day of
the week, it is reasonable to choose all days of the week (1 2 3 4 5
6 7) simultaneously, this way there is no need to perform separate
programming of the days. If you wish to write a different program for
each day, programming should be performed separately for each day of
the week, selecting the days one by one. (If there are days for which you
intend to create the same program, it is sufficient to create the program
only once, because it can easily be applied to any other day with the help
of the “COPY” button as described in Section 3.2).
Press the “• PROG” button again. At that point the next programming step
should be done, i.e. the starting time of switch P1 should be set, which is
indicated on the display of the device by flashing the time value to be set.
Set the starting time of switch P1 by pressing, or pressing repeatedly, •
the large........or........button on the front panel of the device. (The time
can be set at 10-minute intervals).
Press the “• PROG” button again. At this point the next programming step
should be performed, i.e. the temperature of switch P1 should be set,
which is indicated on the display of the device by flashing the temperature
value to be set.
Set the temperature level of switch P1 by pressing, or pressing •
repeatedly, the large........or........button on the front panel of the device.
(The temperature can be set in 0.5°C increments).
- 7 -
Temperature
time
7:00 9:00
12:30 15:00 17:30
23:00
