820048

Compex Wired 3.0 Manual

12
Zoom out
Zoom in
Previous page
1/22
Next page
22 23
By default, all of the channels are active at the beginning of the session. To deselect a channel,
simply press the corresponding button.
Notes: depending on the program, the diagram on the middle of the screen can change. There are
two types of diagram listed below.
Refer to above screenshot, In this case only channel 1 is active. Any change of intensity will only
be performed on channel 1.
INCREASE THE STIMULATION INTENSITIES ON THE SELECTED CHANNELS.
1. WORK PHASE/RELAXATION PROGRAM
These programs always begin with a warm-up phase. After this warm-up phase, a work cycles
phase followed by relaxation occurs (the number of cycles depends on the program) and when all
cycles are completed, the program ends with a recovery phase.
2. WARM UP, RECOVERY TYPE PROGRAM
These program consist of a single phase and have no work phase/relaxation cycle.
These are warm up, recovery, or even pain type program. During this type of program,
frequency variations can occur.
A. Warm up phase
B. Work phase
C. Relaxation phase
D. Recovery phase
E. Work time phase which consists of work
phase and relaxation phase
A. Work time phase
By pressing on the central confirmation button during stimulation, the device goes into pause. At
this point it is possible to skip the current phase or exit the program.
N.B.: The session restarts with intensities equal to 75% of those used prior to the interruption.
At the end of the session a screen with a check
mark appears. Pressing on the central confirmation
or right buttons return you to the home page. To
turn off the device, hold down the On/Off button
for 5 seconds.
F: CONTINUE A STIMULATION PROGRAM
G: END A STIMULATION PROGRAM
B CA
A. skip the current phase. or
exit the program
B. Resume the stimulation
session
C. Skip the current phase. or
exit the program
exit the program
Skip the current phase. or
skip the current phase. or
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Compex Wired 3.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Compex Wired 3.0 in the language / languages: English as an attachment in your email.

The manual is 2.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info