756996
151
Zoom out
Zoom in
Previous page
1/176
Next page
ComNav Admiral P3 Installation & Operation Appendices
Document PN 29010075 V3.1 - 149 -
Appendix 3
Auxiliary Head / Remote Power On
The Admiral P3 SPU is shipped from the factory configured so that power can only be turned
on or off from the main Control Head. The main Control Head is designated as that which is
plugged into the SPU receptacle labelled "J11 - Control Head”. However, the SPU can also
be configured so that it can be turned on or off by a full-function controller plugged into the
receptacles “Aux 1 – J12” or Aux 2 – J13”. The following instructions detail how this is
accomplished.
1) Remove the wiring cover from the SPU and unplug all wiring connectors.
2) Remove ten sheet metal screws around the edges of the SPU. These screws secure the
top portion of the SPU enclosure.
3) Lift the top portion of the SPU enclosure off and set it aside. The top of the printed circuit
assembly will be visible.
4) On the lower right side of the printed circuit assembly are two right-angle pin headers.
They are labelled JP1 and JP2. On each header is a shorting shunt.
5) Change the position of the shunts as shown in the pictures below. JP1 determines
whether power can be turned on from the Controller attached to J13 – Aux 2, while JP2
determines whether power can be turned on from the Controller attached to J12 – Aux 1.
Figure 106 – JP12 & JP13 in Factory Default Position (left) and After Moving Shunts (right)
6) Replace the SPU enclosure top and secure it with ten sheet metal screws.
7) Replace all wiring plugs and the wiring cover.
You will now be able to turn on power from the auxiliary heads simply by pressing the
STANDBY ON/OFF button. Note that the Admiral P3 always powers on in STANDBY mode
with the main Control Head in command, regardless of which station was used to turn the
power on. If power was turned on from one of the auxiliary stations, then to use that station,
you must first take command by pressing the PORT and STARBOARD ARROW buttons.
Note: Power cannot be turned on from a CR-203 or TS-203 Remote.
151


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ComNav Admiral P3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ComNav Admiral P3 in the language / languages: English as an attachment in your email.

The manual is 4,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info