663372
14
Zoom out
Zoom in
Previous page
1/29
Next page
14
PROBLEM
CAUSE
SOLUTION
Heat pump not running
1. No electricity
1. Switch on the electrical power
2. Heat pump not turned on
2. Switch on the heat pump
3. Water pump not running
3. Switch on the water pump
4. Wrong temperature setting
4. Adjust the temperature setting
5. Bypass wrongly adjusted
5. Adjust bypass as shown in manual
6. No gass pressure
6. Call a qualified technician
7. Time delayed operation
7. Wait 3 min for heat pump to start
8. Air temperature below 10°C
8. Wait until temperature has risen
No sufficient heating
1. Obstacles blocking air flow
1. Increase access of fresh air
2. Ice on the evaporator
2. Turn heat pump off (air too cold)
3. Bypass wrongly adjusted
3. Re-adjust the bypass
4. To much water flow
4. Adjust the bypass
5.3 Microcontroller
The ECO+ heat pumps are equipped with a microcontroller on which it is possible to read error codes.
These error codes are formulated by LED lights on the circuit board. To access the circuit board, remove
the 4 screws of the service cover (with “ECO+” on it). At the top of heat pump you will find the PCB
containing the LED lights.
Compare which LEDs are lit to the following error code table
ERROR CODE
LED 1
LED 2
LED 3
LED 4
TROUBLE SHOOTING
000 Standby mode
Standard mode
001 Running mode
Standard mode
002 Air ambient
temp. sensor error
Check the cable connection of the ambient temp. sensor
/ replace the sensor
003 High pressure
protection
Refrigerant system pressure is high, check pressure
gauge, increase the water volume
004 Low pressure
protection
Refrigerant system pressure is low, check pressure
gauge, refeed refrigerant
005 Water flow
protection
Check if the water inlet/outlet connection is correct of not,
increase the water volume
006 Stop running in
limited air temp.
(8°C)
Air temp. is lower than 8°C, stop the heat pump until
temp. over 8°C
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Comfortpool ECO 8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Comfortpool ECO 8 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info