778378

CombiSteel 7455.1660 Manual

16
Zoom out
Zoom in
Previous page
1/61
Next page
16
www.combisteel.com
Troubleshooting
Normal
Microwave oven interfering TV reception
Radio and TV reception may be interfered when
microwave oven operating. It is similar to the
interference of small electrical appliances, like mixer,
vacuum cleaner and electric fan. It is normal.
Dim oven light
In low power microwave cooking, oven light may
become dim. It is normal.
Steam accumulating on door, hot air out of vents
In cooking, steam may come out of food. Most will
get out from vents. But some may accumulate on
cool place like oven door. It is normal.
Oven started accidentally with no food in
It is forbidden to run the unit without any food
inside. It is very dangerous.
Problem
Possible cause
Remedy
Oven cannot be started.
Power cord not plugged in
tightly.
Unplug. Then plug again after 10 seconds.
Fuse blowing or circuit
breaker works.
Replace fuse or reset circuit breaker (repaired
by professional personnel of our company).
Trouble with outlet.
Test outlet with other electrical appliances.
Oven does not heat.
Door not closed well.
Close door well.
According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should be
separately collected and treated. If at any time in future you need to dispose of this product
please do NOT dispose of this product with household waste. Please send this product to
WEEE collecting points where available.
Installation (supplement)
1. The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The
operation of this oven under unfavourable voltage supply conditions can have adverse effects. This device is
intended for the connection to a power supply system with a maximum permissible system impedance Zmax of
0.2 Ohms at the interface point of the user’s supply. The user has to ensure that this device is connected only to
a power supply system which fulfils the requirement above. If necessary, the user can ask the public power supply
company for the system impedance at the interface point.
2. If there is no equipotential bonding conductor in the electric supply, an external equipotential bonding
conductor must be installed at the rear of the appliance (see symbol). This terminal shall be in effective electrical
contact with all fixed exposed metal parts and shall allow the connection of a conductor having a nominal cross-
sectional area up to 10 mm².
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for CombiSteel 7455.1660 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of CombiSteel 7455.1660 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2.98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info