635862
12
Zoom out
Zoom in
Previous page
1/24
Next page
SUPREME B
12
EN
cod. 3541D620 - Rev. 00 - 02/2013
EN
1. GENERAL INSTRUCTIONS
Carefully read and follow the instructions contained in this booklet.
After installing the unit, inform the user about its operation and give him this manual, which is an integral and
essential part of the product and must be kept for future reference.
Installation and maintenance must be carried out by professionally qualified personnel, in compliance with
the current regulations and according to the manufacturer's instructions. Do not carry out any operation on
sealed adjustment parts.
Incorrect installation or inadequate maintenance can result in damage or injury. The Manufacturer declines
any liability for damage due to errors in installation and use, or failure to follow the instructions.
Before carrying out any cleaning or maintenance operation, turn off the gas by means of the special shutoff
devices.
In case of a fault and/or poor operation, deactivate the unit and do not try to repair it or directly intervene.
Contact professionally qualified personnel. Any repair/replacement of the products must only be carried out
by qualified personnel using original replacement parts. Failure to comply with the above could affect the
safety of the unit.
This unit must only be used for its intended purpose. Any other use is deemed improper and therefore haz-
ardous.
The packing materials are potentially hazardous and must not be left within the reach of children.
The unit must not be used by people (including children) with limited physical, sensory or mental abilities or
without experience and knowledge of it, unless instructed or supervised in its use by someone responsible
for their safety.
The unit and its accessories must be appropriately disposed of, in compliance with the current regulations.
The images given in this manual are a simplified representation of the product. In this representation there
may be slight and insignificant differences with respect to the product supplied.
2. OPERATING INSTRUCTIONS
2.1 Introduction
SUPREME B is a high efficiency, instantaneous domestic hot water heater using natural
gas or propane gas, equipped with an open-flue burner with electronic ignition, battery
powered, intended for indoor installation.
2.2 Control panel
Panel
fig. 1 - Control panel
Panel - legend fig. 1
1 DHW temperature display
2 Battery level signalling
3 Burner power adjustment
4 Temperature adjustment
5 Flame symbol
Indication during operation
Table. 1 - Display symbols
During a DHW demand (generated by drawing domestic hot water), the display shows
the actual DHW outlet temperature.
2.3 Lighting and turning off
Preliminary operations and checks
1. Make sure the hot water taps are closed.
2. Open the water heater gas supply cock, located on its gas connection.
3. Make sure the 1.5 V batteries are properly fitted, with the correct polarity (+ and -).
For their replacement see *** 'Replacing batteries' on page 15 ***.
4. Also make sure the batteries have enough charge for water heater operation.
Lighting
Turn the knob to the required water heating level.
fig. 2 - Lighting
The unit will immediately be ready to operate whenever hot water is drawn.
Turning off
The burner goes off automatically when the hot water demand ceases.
No special operation is needed in order to carry out another lighting phase.
To completely shut down the unit, turn the knob to position .
fig. 3 - Unit deactivated
In case of prolonged shutdown close the gas cock ahead of the unit.
B
For long periods of inactivity during the winter months, to avoid frost damage it
is advisable to drain all the water from the water heater.
2.4 Adjustments
Manual setting of burner power
Use the power adjustment knob (ref. 3 - fig. 1) to select the water heater power, minimum
or maximum and intermediate positions depending on the required water heating level.
Turn the knob anticlockwise and the unit heats the water at maximum power. If the tem-
perature is too high, for example in the summer, or when a reduced flow of not very hot
water is necessary, turn the knob clockwise. This reduces the power (and gas consump-
tion). In the position the unit is deactivated.
Temperature setting
The water temperature can be easily set with the temperature selector: turn it to the right
to increase the temperature, or to the left to decrease.
fig. 4 - Temperature adjustment
Faults
After making the adjustments described above, the water heater is ready to operate in
completely automatic mode. When a hot water tap is opened, an intermittent discharge
is generated on the ignition electrode, which causes lighting of the burner.
All the electronic models have an ionisation electrode inserted in the burner to control
correct flame presence. In case of malfunction or no gas with subsequent burner shut-
down, close the hot water tap.
It is then necessary to eliminate the cause or the element preventing the gas from reach-
ing the water heater, e.g. inadvertent closing of the gas cock, empty gas cylinder, etc.
Water heater shutdown status is deactivated by closing and opening the hot water tap.
Repeat the operation if the delivery of hot water is not restored after eliminating the cause
and opening the hot water tap. If the fault persists, contact the After-Sales Technical
Service.
Table. 2 - Table of faults
Symbol flashing: the burner is on.
If the burner is off, this symbol is not displayed.
Water heater outlet temperature.
Symbol fixed. The battery is low. Its replacement is recommended.
Symbol flashing. The battery is discharged and needs to be replaced.
123
5
4
Temperature probe disconnected/open
Temperature read by the DHW sensor < 10°C
Probe or cable short circuited.
Temperature read by the DHW sensor > 99°C
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cointra SUPREME B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cointra SUPREME B in the language / languages: English, French, Portuguese, Spanish as an attachment in your email.

The manual is 2,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cointra SUPREME B

Cointra SUPREME B User Manual - German - 8 pages

Cointra SUPREME B User Manual - Dutch - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info