535645
26
Zoom out
Zoom in
Previous page
1/38
Next page
Page 26 800 Series
Clearing Coin Jams
Should a coin jam occur in the cashbox chute
area, use the following steps to help dislodge
coins:
1. Remove changer from vendor.
2. Keeping changer in an upright position,
remove cashbox chute (located on the back
of the changer) by pulling lower edge out
and down at the same time.
3. Remove any lodged coins.
4. Replace the cashbox chute by pressing in
and up to snap into place.
SECTION 4: MAINTENANCE
Removing/Replacing
Individual Modules
Modular assembly replacement provides the
basis of all COINCO GLOBAL2
®
series
changer repair. Instructions for removing and
replacing
modules are provided below. These modules
should be removed in the following sequence:
ACCEPTOR
To remove the acceptor from the changer,
release the acceptor latch and pull the top of the
acceptor forward, away from the changer.
Unplug ribbon cable from changer. Free lower
acceptor studs from changer housing.
UPPER TUBE SENSE BOARD
Remove the grey, smoked front cover by pulling
out on the left side of the cover at the notch in
the housing. The front cover will swing forward,
exposing the tubes. Remove the four inventory
tubes one at a time by pulling upward. Remove
strain relief bracket, which is located in the
upper left corner of changer housing, by remov-
ing screw. Remove recessed screw that secures
logic board cover and remove cover. Push snap
toward top of housing and remove upper tube
sense board (which will separate from main
logic board upon removal).
PAYOUT BASE
Disconnect the two motor harnesses and the
tube sense harness. Remove the screws from the
bottom, exterior sides of the changer housing
and remove payout base.
MAIN LOGIC BOARD ASSEMBLY
Unplug harnesses from logic board and lift the
logic board out of the housing.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Coinco Global 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Coinco Global 2 in the language / languages: English as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info