634415
14
Zoom out
Zoom in
Previous page
1/19
Next page
- 14 -
Fig.11A for Briggs engine Fig.11B for Briggs engine
Fig.11C for Cobra engine Fig.11D for Cobra engine
NOTE: Replace the filter if frayed, torn, damaged or unable to be cleaned.
9.2 CUTTING BLADE
CAUTION: Be sure to disconnect and ground the spark plug wire before working on the cutting blade to
prevent accidental engine starting. Protect hands by using heavy gloves or a rag to grasp the cutting
blades .Tip the mower as specified in separate engine manual. Remove the hex bolt and washer which holds
the blade and blade adapter to the engine crankshaft. Remove the blade and adapter from the crankshaft.
WARNING: Periodically inspect the blade adapter for cracks, especially if you strike a foreign object.
Replace when necessary.
For best results your blade should be sharp. The blade may be re-sharpened by removing it and either grinding
or filing the cutting edge, keeping it as close to the original bevel as possible. It is extremely important that
each cutting edge receives an equal amount of grinding to prevent an unbalanced blade. An improper blade
balance will result in excessive vibration, causing eventual damage to the engine and mower. Be sure to
carefully balance the blade after sharpening. The blade can be tested for balance by balancing it on a round
shaft screwdriver. Remove metal from the heavy side until it balances evenly.
Before re-assembling the blade and the blade adapter to the mower, lubricate the engine crankshaft and the
inner surface of the blade adapter with light oil. Install the blade adapter on the crankshaft. Refer to figure 12.
Place the blade with the part number facing away from the adapter. Align the washer over the blade and insert
the hex bolt. Tighten the hex bolt to the torque listed below:
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra RM46C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra RM46C in the language / languages: English as an attachment in your email.

The manual is 1,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info