634406

Cobra MX514SPB Manual

13
Zoom out
Zoom in
Previous page
1/19
Next page
- 13 -
cutting in thick grass it may be necessary to use one of the slowest speeds in order to get a clean well mowed cut. When mowing
long grass you may have to cut the lawn in two passes, lowering the blade another 1/3 of the length for the second cut and
perhaps cutting in a different pattern than was used the first time. Overlapping the cut a little on each pass will also help to clean
up any stray clippings left on the lawn. The mower should always be operated at full throttle to get the best cut and allow it to do
the most effective job of mowing.
Clean underside of deck: Be certain to clean the underside of the cutting deck after each use to avoid a build-up of grass, which
would prevent proper mulching. Mowing leaves. The mowing of leaves can also be beneficial to your lawn. When mowing leaves
make sure they are dry and are not laying too thick on the lawn. Do not wait for all the leaves to be off the trees before you mow.
WARNING: if the mower blade strikes a foreign object, then stop the engine. Remove the wire from spark plug, thoroughly
inspect the mower for any damage and repair the damage before restarting and operating the mower. Extensive vibration of the
mower during operation is an indication of serious damage. The unit should be promptly inspected and repaired.
7.7 GRASS CATCHER
There is a level indicator on the top of the grass catcher that shows whether the catcher is empty or full :
- The level indicator inflates if the catcher is not full during the mowing. (Fig. 12B)
- If the catcher is full, the indicator collapses; once this happens, stop mowing immediately and empty the catcher, make sure it is
clean and ensure its meshwork is ventilated. (Fig. 12A)
IMPORTANT:
If the position of indicator opening is very dirty, the indicator will not inflate-in this case, clean the position of indicator opening
immediately.
Fig. 12A Fig. 12B
7.8 DECK
The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings, leaves, dirt or other
matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent proper mulching. The deck may be
cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug wire is disconnected).
7.9 HEIGHT ADJUSTMENT INSTRUCTIONS
CAUTION: Do not at any time make any adjustment to lawnmower without first stopping the engine and disconnecting the
spark plug wire.
CAUTION: before changing mowing height, stop mower and disconnect spark plug cable.
Your mower is equipped with a central height adjustment lever offering 7 height positions.
The height (the blade to the ground) can be adjusted from 25mm to 75mm (7 height positions). (Fig.13)
1. Stop the mower and disconnect spark plug cable before changing mower cutting height.
2. The central height adjustment lever offers you 7 different height positions.
To change the height of cut, squeeze adjuster lever toward the wheel, moving up or down to selected height.
Level indicator
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra MX514SPB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra MX514SPB in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info