634471
9
Zoom out
Zoom in
Previous page
1/16
Next page
8
Training
1. Become familiar with the instruction manual before attempting to operate the
product.
Preparation
1. THIS PRODUCT CAN CAUSE SERIOUS INJURIES. Read the instructions
carefully for the correct handling, preparation, maintenance, starting and stopping
of the product. Become familiar with all controls and the proper use of the product.
2. Never allow children to use the product.
3.
Beware of overhead power lines. Do not use the product in any position that
causes any part to come within 10 metres of overhead electrical lines.
4. Avoid operating while people, especially children, are nearby.
5. Dress properly! Do not wear loose clothing or jewellery, which can be caught
in moving parts. Use of sturdy gloves, non-skid footwear and safety glasses is
recommended.
6. If the cutting mechanism strikes any foreign object or the product starts making
any unusual noise or vibration, switch the product off, allow the product to stop,
disconnect it from the power supply and let it cool down. Take the following steps:
inspect for damage,
check for, and tighten, any loose parts,
have any damaged parts replaced or repaired with parts having equivalent
specifications
WARNING! Wear ear and eye protection!
7. In case of emergency release the on/off switch and remove the harness from
your shoulder.
Additional safety warnings
1. Keep hands and feet away from the cutting devices at all times and especially
when switching the product on.
2. Do not try to grasp or remove trimmings when the product is running. Only
remove trimmings when the product is switched off and disconnected from the
power supply.
3. Always be sure of a safe and secure operating position, whilst using the product.
Always be sure of your footing when using steps and when using your product.
4. Check cutting device regularly for damage, and if damaged repair immediately.
5. Do not overload the product.
6. Check immediately if the product starts to vibrate abnormally. Excessive vibration
can cause injury.
7.
Switch the product off when the cutting device is blocked. Disconnect from the
power supply and remove the blockage. Inspect the cutting device for damage
before using the product again.
8. Follow the maintenance and repair instructions for this product. Never carry
ADDITIONAL SAFETY INSTRUCTIONS FOR POLE
HEDGE TRIMMER
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra LRH40E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra LRH40E in the language / languages: English as an attachment in your email.

The manual is 4,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info