634435
17
Zoom out
Zoom in
Previous page
1/32
Next page
7). Fit side cover, ensure that the bar fastening bolt fits into
the screw thread of the locking knob (14). Screw
on the locking knob to tighten the side cover. (See Fig.
12).
6). Mount the bar on the bar fastening bolt (16), fit the
chain onto the drive sprocket (17) and guide the guide
bar, so that the bar fastening bolt and the two guide
pins (B) fit into the keyway of the guide bar. (See Fig.
11)
8). The chain is not yet tensioned now. Tensioning the chain applies as described under
“TENSIONING CHAIN”. After running the chain saw around 1 hour, adjust the chain
tension to 2mm by applying 9N of torque.
3.1.2 TENSIONING CHAIN
-Always check the chain tension before use, after the first cuts and regularly during
use, approx. every 5 cuts.
-Upon initial operation, new chains can lengthen considerably. This is norm
al during
the break-in period, and the interval between future adjustments will lengthen quickly.
WARNING: Unplug the chain saw
from the power source before
adjusting the saw chain tension.
WARNING: Cutting edges on the chain are sharp. Use protective
gloves when handling the chain. The chain will be hot after cutting
material.
WARNING: Maintain proper chain tension always. A loose chain will
increase the risk of kickback. A loose chain may jump out of the guide
bar groove. This may injure the operator and damage the chain. A loose
chain will cause the chain, chain bar and sprocket to wear rapidly.
12
11
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra CS40E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra CS40E in the language / languages: English as an attachment in your email.

The manual is 4,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info