2
SET-UP
Read these instructions
carefully before programming
your remote control!
BRAND SEARCH PROGRAMMING MODE
A
1.Turn ON the appliance:
– if a VCR, insert a cassette
– if SAT, select a program
– if DVD, insert a DVD.
2. In the code book enclosed, look for the
brand of your appliance and make a
note of the code indicated at the side
(e.g. Philips 001) or the code for the
brand indicated by the arrow.
3.Press and release the TV - VCR - SAT -
DVD selection key for the appliance you
want to use:
– the TV key is used to search only for
the TVs of the brand selected
– the VCR key is used only for the VCRs
– the SAT key is used only for the SATs
– the DVD key is used only for the DVDs.
4.Hold down the SHIFT and ON/OFF keys
together until the TV - VCR - SAT - DVD
selection key starts to flash indicating
that the remote control is in
programming mode.
5. Release the keys. Within 15 seconds,
enter the brand code previously
identified (e.g. 001).
The TV- VCR - SAT -DVD selection key
flashes more quickly to indicate that the
remote control is ready for the search.
6. Point the remote control at the
appliance. Press and release slowly one
of the most frequently used keys several
times STOPPING when the appliance
responds correctly to the command.
7. When the appliance responds correctly,
press SHIFT to confirm. Three flashes
indicate that the operation has been
completed correctly.
Additional check
Check that some of the other functions
used on your original remote control are
working correctly. If the commands
function incorrectly or erratically, you have
probably entered a code for a similar but
different remote control.
In this case, repeat the search procedure
from point 3.
Identify and make a note of the code
for the appliance which you have
searched for, following the code
noting procedure (see “NOTING THE
PROGRAMMED CODE” section).
Warning: program one appliance at a time.
FITTING THE BATTERIES
Before programming and using the remote control, fit the batteries.
The remote control requires 2 new AAA/LR03 alkaline batteries.
Insert the batteries as shown.
• The batteries must be changed once a year.
• If the TV - VCR - SAT - DVD selection keys start to
flash during use, this indicates that the batteries are
low and should be changed.
• When you remove the batteries, fit the new ones
within 5 minutes or you may have to reprogram your
remote control.
• Make a note of the codes for the TV - VCR - SAT -
DVD equipment on the adhesive label inside the
battery cover. This note will be handy if you have to
reprogram your control.
TV
DVD
0
0
1
SAT
VCR
NOTE: THE SELECTION KEY STOPS
FLASHING.
The remote control leaves the
programming mode and the
TV - VCR - SAT - DVD selection
key stops flashing:
•
if no keys are pressed for 15 seconds
•
if an invalid brand code is entered
•
if the code search list is completed. In
this case, go back to point 3 or switch to
programming mode C
•
if you press the TV - VCR - SAT - DVD -
F1 - F2 - F3 - F4 keys by mistake.
To program the TOPTEL 4 Plus
remote control, follow the indications
in section A , B or C .
