773875
18
Zoom out
Zoom in
Previous page
1/20
Next page
18
6. FAQs
PROBLEM
PROBABLE CAUSE SOLUTION
The device
does not
heat up
The device is in energy-saving
mode
Due to the thermal inertia, the device transfers heat
to the room; should you need more temperature,
increase the device temperature.
The room
does not
reach the
desired
temperature
Incorrect setting of the set
temperature
Check the set temperature on the display to verify it
is the desired temperature.
Improper sizing The power is not the adequate for the place in which
it has been installed.
Excessive height
Make sure the system is installed at the recommended
height or rise set temperature to compensate probe
reading
Input and output grids are
obstructed
Do not place anything on top of the radiator and do
not install it inside a hole made in the septum.
The
radiator
does not
operate
Set temperature below room
temperature
Rise the radiator’s set temperature until it is 1 degree
above the room temperature
Control panel switch and
protection down
Check that the automatic control is not down. If it is
down put it up.
Make sure the installation is correct and that there are
independent lines for the heating system with a 2.5
mm2 cable gauge and a maximum power of 3500 w.
Switch is off Set the switch in position I.
Program is OFF Check that the set program is the chosen one or set the
one you desire.
The
radiator
stains the
walls
Radiator located at a very low
height
The minimum height from the floor to the radiator’s
lower part must be at least 25 cm.
Dust accumulation in the lower
grid.
Vacuum it. The vacuuming should be done at the
beginning of each heating season.
Type of painting on the wall Paints with a high content in rutile are likely to
darken.
Blocked
buttons
No response from operating
buttons
Press buttons MODE and simultaneously for 3
seconds.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Climastar Silicium Smart Pro Bathroom at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Climastar Silicium Smart Pro Bathroom in the language / languages: English as an attachment in your email.

The manual is 1.85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info