650979

Climadiff CLPP209 Manual

36
Zoom out
Zoom in
Previous page
1/128
Next page
36
4. INSTALLATION INSTRUCTIONS
Before using your wine cellar
Remove the inner and outer packaging.
Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This will reduce the
possibility of malfunction of the refrigeration circuit due to transport.
Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar
Your wine cellar must be positioned in a room with an ambient temperature between +16°C and
+32°C. Alternatively, if the cellar is fitted with the winter system, the range is extended to 0°C to 32°C.
Installing your wine cellar
This wine cellar is designed for free-standing installation.
Position it in a place with sufficient strength to support its weight when loaded.
To get the best from your appliance with the lowest energy consumption, do not place the appliance close
to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a room
which is too cold.
Connect the cellar to a single socket.
Leave a 10 cm gap between the back of the cellar and the wall. Ensure that your wine cellar is perfectly
horizontal, and then slightly raise the only one front foot (use of a spirit level is recommended). This will
prevent any movement due to instability, causing noise and vibration, and will ensure that the door seals
perfectly.
Adjusting the thermostat
Tip: immerse a suitable thermometer in a clear glass bottle filled with water and place it in the
middle of the cellar. Wait at least 24 hours before checking the temperature. Then adjust the
thermostat in the light of the temperature read and that required.
The thermostat in your wine cellar only controls the production of cold air. If your wine cellar is equipped with
the winter system and is intended for use in an unheated area, the heating circuit is factory preset and you
do not need to adjust it.
The temperature setting is possible between 8°C and 18°C (at a recommended room temperature of 25°C).
When the fan is activated, the temperature will be similar within the whole cavity according to your setting.
When the fan is deactivated, for example if you set the temperature at 12°C, the bottom temperature will be
between 9°C and 12°C, and the top temperature will be between 12°C and 15°C.
To activate or deactivate the cooling fan, please use the on/off switch located on the left side of the control
board.
Key to increase the temperature
Key to decrease the temperature
Key to activate or deactivate the light
Key to select in order to set the temperature
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Climadiff CLPP209 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Climadiff CLPP209 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info