599254

Cleopatra Wellspring 130 Manual

12
Zoom out
Zoom in
Previous page
1/290
Next page
12
Trafoanschluss ist nur bei Kabinen
ohne Farblicht notwendig!
Der mitgelieferte Trafo muss im
Trockenbereich (Schutzzone 3)
installiert werden. Das Trafokabel
ermöglicht die Installation des
Trafos bis zu max. ca. 6 m entfernt
vom Eckschrankmodul. Der Trafo
muss jederzeit zugänglich sein. Ein
beschädigter Anschluss kann nicht
ersetzt werden. Der Trafo darf dann
nicht mehr betrieben werden.
Der Trafo wird an eine Steckdose
230V/50Hz angeschlossen und
muss über eine Fehlerstrom-
Schutzeinrichtung (RCD) mit einem
Bemessungsdifferenzstrom von
≤ 30 mA abgesichert werden.
D Leerrohr 4 für Potentialausgleich:
Potentialausgleich (Kabel mit 4 mm²
/ Länge: 3 m) vorinstallieren.
E idealer Bereich für Bodenablauf
(Ablaufleistung > 0,7 l/s)
F idealer Bereich für Wasserzulauf aus
der Wand (nur festes- oder flexibles
Rohrmaterial verwenden).
TWW Trinkwasser warm DN15 ½“ +
bauseitig vorbereitetes Installati-
onssystem zwischen TWW-Anschluss
und Kabine.
TWK Trinkwasser kalt DN15 ½“ +
bauseitig vorbereitetes Installations-
system zwischen TWK-Anschluss und
Kabine.
Anschluss für Wasserzulauf und der
Wasserablauf sind nach den derzeit
gültigen DIN 1988/EN 1717 / DIN 1986/
EN 12056 und den örtlichen Vorschriften
zu installieren (Anschlußmuffe DN15 ½“,
bündig Fliesen).
TECHNISCHE DATEN
cable:
The Wiring conduit 3 for the external
transformer connection is necessary
only for cabins without colour light!
The transformer must be installed
in the dry area (protection zone
3). The cable provided allows the
transformer to be installed max.
approx. 6 m from the corner cabinet.
The transformer must be accessible
at all times. A damaged connection
cable cannot be replaced, and the
transformer must not be operated in
this case.
The transformer will be connected
to a socket for electrical supply (230
V/50 Hz AC) and must be fused via a
2-pole RCCB with a residual current
of ≤ 30 mA.
D Wiring conduit 4 for cross-section:
pre-assemble cross section (cable
with 4 mm² / length: 3 m)
E ideal area for waste. The waste must
be able to pass 0,7 l/s.
TWW hot water (left) DN15 ½“
TWK cold water (right) DN15 ½“
Connections for water inlet and drain
have to be installed according to the
currently valid DIN 1988/EN 1717 /
DIN 1986/EN 12056 as well as local
regulations (connection sleeve DN15
½“, flush with tiles).
TECHNICAL DATA
Prevedere una scatola di collegamento
con il collegamento elettrico 230V/N/
PE/50Hz per il cavo d’alimentazione di
corrente elettrica. La protezione deve
essere eseguita attraverso un interruttore
automatico a corrente residua (RCD) con
una taratura della corrente differenziale
pari a ≤ 30 mA.
Il tubo vuota di posa 3 per la connessione
del trasformatore esterno è necessario
solamente con cabine prive di
Cromoterapia.
C Tubo vuoto di posa 3 con Ø interno 25
mm per cavo del trasformatore:
Il trasformatore in dotazione deve
essere installato in zona asciutta (zona di
protezione 3). Il cavo del trasformatore
consente di installare il trasformatore
fino ad una distanza massima di ca.
6m dal modulo armadietto angolare. Il
trasformatore deve essere accessibile
in qualsiasi momento. Non è possibile
sostituire un collegamento danneggiato.
In tal caso non è più permesso utilizzare
il trasformatore.
Il trasformatore viene collegato ad una
presa di alimentazione 230V/50Hz e deve
essere protetto attraverso un interruttore
automatico a corrente residua (RCD) con
una taratura della corrente differenziale
pari a ≤ 30 mA.
D Tubo vuoto di posa 4 per la compensazione
del potenziale: preinstallare la
compensazione del potenziale (cavo
con 4 mm² / lunghezza: 3 m).
E Zona ideale per lo scarico a pavimento
(velocità di scarico > 0,7 l/s)
TWW acqua potabile calda (lato
sinistro) DN15 ½“
TWK acqua potabile fredda (lato
destro) DN15 ½“
La connessione dell‘acqua e dello scarico
devono essere predisposte seguendo le
norme valide DIN 1988/EN 1717 / DIN 1986
/ EN 12056 e in conformità alla normativa
vigente nel paese d‘installazione (connettere
con manicotto DN 15 1/2“ a livello delle
piastrelle)
DATI TECNICI
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleopatra Wellspring 130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleopatra Wellspring 130 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 28,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info