462047

ClearOne PRO 880T Manual

146
Zoom out
Zoom in
Previous page
1/345
Next page
141
Select the Enable Compressor checkbox to activate the compressor. Using the compressor, you can change
the gain transfer characteristics of the signal path and control the dynamics of a signal. Compressor settings are
described below.
Group
Use the Group radio buttons to assign this compressor to a compressor group. The default is None. When you
assign a compressor to a compressor group—such as a group of two compressors configured for left and right
stereo channels—the compressors will monitor each other. When one channel compresses, all compressors in the
group compress together.
A compressor group must be configured for a single unit; a group cannot control compressors from multiple units.
Post Compressor Gain
Adjust the compressor gain with the slider or by using the Up/Down arrow buttons. The graph reflects the input/
output decibel levels with the gain, ratio, and threshold settings you select.
Threshold
Determines the RMS level at which the compressor begins to operate. The range is from -30 to +20dBu. The default
is 0dBu.
Ratio
Changes the rate of compression applied to the input signal as the signal exceeds the threshold level. The range is
1:1 to 1:20dB. The default is 1:1.
Attack
Sets the time increment used to reduce the signal from input level to the prescribed output level when the threshold
is exceeded. The range is 0 to 100ms in .5ms steps. The default is 10ms.
Release
Sets the time increment used to restore the signal to the input level when the signal drops below the threshold. The
range is 100ms to 2 seconds, in 5ms increments. The default is 500ms.
… 146 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ClearOne PRO 880T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ClearOne PRO 880T in the language / languages: English as an attachment in your email.

The manual is 10,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info