551999
26
Zoom out
Zoom in
Previous page
1/42
Next page
ENGLISH
ENGLISH
26
Overview of the Components
1 Control
2 Thermostat
3 Control lamp
Instructions for Use
Use
Use the electric blanket on the mattress of your bed. The electric
blanket must be attached to the mattress by means of the straps.
Place the electric blanket on the mattress (see Figure A).
Release the straps and guide them under the mattress (see
Figure B).
Pass the straps through the loops on the other side of the
electric blanket and fasten them with knots.
The electric blanket must lie smoothly on the mattress and
must not be tucked in or contain any creases.
Pass the lead out of the bed in such a way that you can still
operate the thermostat.
WARNING:
Under no circumstances should the thermostat be covered
by bedding or cushions! Otherwise this might result in a
malfunction.
Electrical Connection
Please ensure that the device voltage (see type plate) and
mains voltage are the same.
Insert the mains plug into a properly installed 230 V, 50 Hz
socket with earthing contact.
Switching on
Move the regulator on the thermostat (2) to the desired
setting.
The control lamp (3) lights up and shows that the device is
working.
ޥ NOTE:
On the fi rst few occasions that this device is used unusual
odours may be produced. These are harmless and disappear
the more the device is used.
Thermostat Settings
You can select from the following settings:
Setting Function Instructions for Use
0
Off
1
Low. Slight
warmth.
Suitable for operation
during the night.
2
Medium
Suitable for operation
during the night.
3
High
Not suitable for opera-
tion during the night.
Only for warming up
the bed before getting
into it
ޥ NOTE: You can read off the setting on the control lamp (3).
Switching off
Turn the thermostat control to
0
(off).
Only then should you remove the plug from the mains
socket.
Cleaning
WARNING:
Always remove the mains plug from the socket before cleaning
the device.
CAUTION:
The electric blanket together with the thermostat must not
be placed in the washing machine or dry-cleaned.
Do not immerse the components in water.
The thermostat must not be allowed to become wet.
If you use water to clean the electric blanket, this must not
be warmer than 30°C. Otherwise the material could shrink
and damage the electrical system.
Do not use any abrasive cleaners or solvents.
Do not use any stain remover such as foam or spray.
Removing Stains from the Electric Blanket
Wipe off the affected area with a damp cloth or sponge. In
the case of stubborn stains a gentle solution of soapy water
may be used.
Excess water can be dabbed off with a towel.
Drying the Electric Blanket
After cleaning, allow the material to dry in the air.
To this purpose the entire electric blanket should be hung
over a line.
Do not use any pegs or similar items.
WARNING:
The electric blanket must be completely dry before it is used
again.
Thermostat
You should only wipe off thermostat with a dry cloth.
Storage
Remove the mains plug from the socket and allow the
electric blanket to cool down for approx. 20 minutes.
Fold the electric blanket together gently and store the entire
product in the storage bag.
CAUTION:
Store the product in a dry place.
Do not place any heavy objects on the device.
05-WUB 3144 26 06.03.2007, 9:55:26 Uhr
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic WUB 3144 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic WUB 3144 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 2,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info