Manual Clatronic wkt 3093 (page 26 of 42) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian)

375705

Zoom out

Zoom in

1/42

ENGLISH

Use

Boiling Water and Automatic Switch-Off

1. Place the machine on a ﬂ at surface.

2. Open the water boiler with the button on the lid. Then ﬁ ll it

with clear water. You can read off the level on the internal

water level indicator. Fill only up to the maximum mark

(MAX).

3. Close the lid until it is heard to lock into place and is ﬁ xed

ﬁ rmly in position.

4. Place the kettle ﬂ ush on the base.

5. Electrical connection

• Check whether the electrical voltage that you intend to

use is the same as that of the machine. Details are to be

found on the label on the base.

• Only connect the machine to a properly installed 230 V,

50 Hz safety socket.

6. Move the thermostat to MAX and turn the device on by the

switch on the handle. To control lamp lights up.

7. After boiling has ﬁ nished the kettle switches off automatical-

ly, or you can push the switch upwards to interrupt or stop

the boiling process.

WARNING: Danger of scalding!

• When pouring the water out, keep the lid closed.

• During operation the housing becomes hot. Do not

touch it and allow the device to cool down before

storing it away.

8. Always pour water that is no longer required away immedia-

tely.

Heating Water

1. Place the machine on a ﬂ at surface.

2. Follow the steps as described in the section „Boiling water

and automatic switch-off“ point 1-5.

3. Move the thermostat to a value between „MIN“ and „MAX“

and turn the device on with the switch. The control lamp

lights up.

4. The temperature has been reached when the control lamp

goes out.

5. If you would like to stop heating and remove some of the

water, turn the device off by the switch.

Switching off

• If you wish to switch the device off, turn the switch to 0 (off),

the thermostat to MIN and remove the plug from the socket.

The control lamp goes off.

• Emptying the water container.

Mains Cable Take-up Device

The mains cable can be wound up on the base.

Cleaning

• Always pull out the plug from the mains socket before

cleaning and wait until the unit has cooled down.

• Do not use any wire brush or other abrasive objects.

• Do not use any acidic or abrasive detergents.

• Never immerse the device or the base in water or other

liquids.

Water Container

• Rinse the water container out with clean water. Then dry it

off with a cloth.

Exterior of the Housing

• Clean the housing after use with a slightly damp cloth.

Decalciﬁ cation

• The frequency of the decalcifying operation depends on the

hardness of the water and on how often the appliance is

used.

• If the machine switches off before the water boils, it probably

needs to be decalciﬁ ed.

• Please do not use vinegar but a commercially available

decalciﬁ cation agent on the basis of citric acid. Only use the

quantities stated in the instructions.

ޥ NOTE:

After descaling the device boil fresh water in it several times

(approximately 3-4 times) in order to remove any residues. Do

not consume this water.

Troubleshooting

• It is not possible to switch the machine on.

Possible Cause:

After being used without or with too little water the machine

has not cooled down sufﬁ ciently.

Remedy:

Allow the machine to cool down for 15 min.

• The machine switches off before the water has boiled.

Possible Cause:

The heated base is coated with too much lime or the circuit

of the plug is overloaded.

Remedy:

Descale the machine as instructed.

Check the mains connection.

• The machine does not switch off.

Possible Cause:

The lid is not closed.

Remedy:

Close the lid until it locks in place.

05-WKT 3093 26 11.09.2006, 14:51:33 Uhr

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic wkt 3093 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 1,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Clatronic wkt 3093 Manual

Product: