375314
23
Zoom out
Zoom in
Previous page
1/40
Next page
ENGLISH
ENGLISH
23
Use
1. Place the machine on a fl at surface.
2. Please use the handle in the lid to open the kettle. Then fi ll
in the water. Please only fi ll up to the maximum (MAX) mark.
You can check the level on both sides of the appliance with
the water level display.
3. Close the lid until you hear it lock in place.
4. Place the kettle fl ush on the base.
5. Electrical connection
Check whether the electrical voltage that you intend to
use is the same as that of the machine. Details are to be
found on the label on the base.
Only connect the machine to a properly installed 230 V,
50 Hz safety socket.
6. Switch on the kettle by pressing the switch. To control lamp
lights up.
7. After boiling has fi nished the kettle switches off automati-
cally, or you can push the switch upwards to interrupt or stop
the boiling process.
WARNING: Danger of scalding!
When pouring the water out, keep the lid closed.
During operation the housing becomes hot. Do not touch it
and allow the device to cool down before storing it away.
Switching off
If you would like to turn the kettle off, push the switch up-
wards (0) and remove the plug from the socket. The control
lamp goes off.
Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.
Cleaning
WARNING:
Always turn the device off before cleaning it and remove
the mains plug. Wait until the device has cooled down.
Never immerse the device or the base in water or other
liquids.
CAUTION:
Do not use any wire brush or other abrasive objects.
Do not use any acidic or abrasive detergents.
Water Container
Rinse the water container out with clean water. Then dry it
off with a cloth.
Exterior of the Housing
Clean the housing after use with a slightly damp cloth.
There is a permanent fi lter in the spout. In order to clean the
lter, pull it out with the lid open. Rinse out the fi lter with run-
ning water. Reinsert it, taking note of the guide mechanism.
Decalcifi cation
The frequency of the decalcifying operation depends on the
hardness of the water and on how often the appliance is
used.
If the machine switches off before the water boils, it probably
needs to be decalcifi ed.
Please do not use vinegar but a commercially available
decalcifi cation agent on the basis of citric acid. Only use the
quantities stated in the instructions.
ޥ NOTE:
After descaling the device boil fresh water in it several times
(approximately 3-4 times) in order to remove any residues. Do
not consume this water.
Troubleshooting
It is not possible to switch the machine on.
Possible Cause:
After being used without or with too little water the machine
has not cooled down suffi ciently.
Remedy:
Allow the machine to cool down for 15 min.
The machine switches off before the water has boiled.
Possible Cause:
The heated base is coated with too much lime or the circuit
of the plug is overloaded.
Remedy:
Descale the machine as instructed.
Check the mains connection.
The machine does not switch off.
Possible Cause:
The lid is not closed.
Remedy:
Close the lid until it locks in place.
Technical Data
Model: ..............................................................................WK 3098
Power supply: ............................................................230 V, 50 Hz
Power consumption: ..........................................................2200 W
Protection class: ........................................................................... Ι
Filling quantity: .........................................................max. 1,7 Litre
Net weight: ........................................................................0,75 kg
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
05-WK 3098 Neu.indd 2305-WK 3098 Neu.indd 23 08.05.2009 8:23:59 Uhr08.05.2009 8:23:59 Uhr
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic wk 3098 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic wk 3098 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info