714083
30
Zoom out
Zoom in
Previous page
1/52
Next page
WA3745_IM 23.07.19
30
CAUTION:
This appliance is not intended to be immersed in water during
cleaning. Please observe the instructions that we have included
for you in the chapter “Cleaning”.
Starting-Up the Appliance
Notes for Use
Before you prepare the rst wafes for consumption:
Remove any packaging that is still present. Unwind the
mains lead completely.
Clean the housing and the baking surfaces with a damp
cloth.
Electrical Connection
1. Check whether the mains voltage that you want to use
matches the one of the appliance. You will nd the infor-
mation about this on the type plate.
2. Set the temperature control to the
position (off).
3. Insert the plug in a duly installed protective contact
socket. The red control lamp will light up.
Non-Stick Coating
1. Lightly grease the baking surfaces before the appliance
is used for the rst time.
2. Use the appliance for about 10 minutes with the toasting
surfaces closed (see “Using the Appliance”).
3. Remove the mains plug from the socket and allow the
appliance to cool down.
NOTE:
Any smoke or smells produced during this
procedure are normal. Please ensure sufcient
ventilation.
Do not eat the wafes prepared during rst time
operation.
4. After the appliance has cooled down, wipe the baking
surfaces off with a paper towel.
Using the Appliance
NOTE:
Keep the baking surfaces closed while heating.
After heating up the appliance, the green control lamp
will turn off.
The red control lamp remains on to show that the
appliance is working.
The green control lamp switches on and off during
baking in order to maintain the baking temperature.
The baking section should always be closed in the
intervals between baking.
1. Set the temperature control to MAX in order to heat up
the appliance.
2. Open the lid and add dough onto the centre of the baking
surfaces.
NOTE:
To obtain even wafes, spread the dough. Please
put in only enough dough so that the lower baking
surface is covered.
The dough should be lled in quickly as otherwise
the wafers will not brown evenly.
3. Gently close the lid and briey keep it pressed down.
WARNING:
Be careful of the emitted steam. Risk of burns!
4. The desired baking temperature can be set with the
selector.
NOTE:
The baking process lasts approx. 3 - 6 minutes.
This may vary depending on the consistency of the
mixture.
If your wafes are too dark, set the temperature
control to a lower setting.
5. Remove the ready-to-eat wafes with a wooden fork or
similar.
6. Place the wafe on a platter or plate and sprinkle some
icing sugar on top of it.
7. Lightly grease the baking surfaces again as required
after each baking process.
CAUTION:
Do not use pointed or sharp objects to avoid damaging
the coating of the baking surfaces.
Switching Off
In order to stop operation, set the temperature control to the
position (off). Then disconnect the mains plug from the
wall socket. The red control lamp goes off.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic WA 3745 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic WA 3745 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info