400941
24
Zoom out
Zoom in
Previous page
1/42
Next page
ENGLISH
ENGLISH
24
Installation
Mains Lead
Remove the mains lead from the storage compartment in the
bottom section.
Mixing Vessel
1. Check any preassembled parts! (Fig. A + B)
The safety disc (4), sealing ring (5), blade block (6) and
screw top (7) must be assembled in the correct order.
CAUTION:
• Do not forget to insert the sealing ring as otherwise
the carafe will leak.
Always place the sealing ring on the blade block.
The screw top must be straight when screwed into
place.
The three guide mechanisms of the safety disc must
lie in the recesses of the screw top.
2. Place the carafe on the motor housing (8) (Fig. C). You can
select whether the handle of the carafe should point to the
left or right.
ޥ NOTE:
When the carafe is placed in position the assembled safe-
ty disc presses on the safety switch of the motor housing.
If incorrectly installed the mixer cannot be operated.
Instructions for Use
Please clean the mixer vessel, the lid and seal before initial
use in warm soapy water.
Please cut the items that are to be mixed into small pieces
beforehand.
Ingredients: Do not put any hot items into the mixing ves-
sel.
Seal: The seal can also be used as a measuring jug (full to
the brim = 50 ml).
Short-term operation: The device is suitable for short-term
operation of not more than 1 minute. After this time it should
be switched off.
Pulse operation: Pulse mode is turned on by turning the
switch to the “P” position and releasing it again. The device
should not be used in this mode for more than 1 minute.
Allow it to cool down for 2 minutes before using it again!
• Chopping up Ice Cubes: The blade in the mixing vessel
is also suitable for chopping up ice cubes. Please only fi ll
the carafe up to 1/3 full with ice cubes. Only pulse mode “P
should be used for chopping up ice cubes.
Operation
Electrical connection
Check whether the electrical voltage that you intend to use is
the same as that of the machine. Details are to be found on the
label on the base.
Preparation
Ensure that the function switch (9) is in the “0” position.
Place the mixing vessel in position.
Now put the ingredients that are to be mixed into the mixing
vessel (max. 1.5 litres).
Press the lid (2) tightly onto the carafe (Fig. D). It must
tightly seal the mixer vessel.
Close the lid with the seal (1) (Fig. E). Note the recesses on
the inside of the lid. Turn the seal tight in a clockwise direc-
tion.
Connect the mains lead to a properly installed 230 V, 50 Hz
safety power socket. The switch ring (10) lights up.
Please hold the carafe fi rmly during mixing.
Mixing
For constant mixing (continuous mode):
If the device is operated on levels 1 and 2 the switch locks in
place in the respective position.
Level 1 = low rpm
Level 2 = high rpm
Shift the selector to “0” to switch off the appliance.
For pulse mode (mixing at brief intervals):
Move the switch to the “0” position. The switch snaps into
place. The appliance is off now. Turn the switch now to
position “P”. The switch must be kept in this position for
the desired interval. When the switch is released, it returns
automatically to “0” position.
Adding further ingredients to be mixed
Please switch off the machine before doing so. Spices or other
ingredients that are to be mixed can be inserted through the hole
in the seal.
Stopping Operation
Turn the switch to the “0” position.
Remove the mains plug from the socket
. The illumination
goes off.
Remove the mixing vessel.
Take off the lid before pouring.
ޥ IMPORTANT NOTE:
Citrus juices and food containing acids should never be
stored in metal vessels.
The mains lead can be stored in the bottom section.
Cleaning
Preliminary Cleaning
• Half ll the mixing vessel with water and turn the switch to
P” for approximately 10 seconds. Then pour out the liquid.
WARNING:
Always remove the plug before cleaning!
Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or fi re.
05-UM 3284.indd 2405-UM 3284.indd 24 09.04.2009 9:57:10 Uhr09.04.2009 9:57:10 Uhr
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic um 3284 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic um 3284 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info