Operation
1. Only connect the unit to a properly installed and earthed power socket
(230 volts, 50 Hz).
2. Browning control: The device has an electronic browning control. The brow-
ning time is shown in the display after the device has been switched on. This
time counts down to zero. An acoustic signal is heard at the end of the toasting
process. In order to set the degree of browning, turn the selector switch to the
required level from the lightest level 1 to the darkest level 5. If you are not cer-
tain which level to use, begin with a low number.
Note: Position 1 corresponds to 1.35 minutes toasting time and increases up to
5 minutes on level 5.
3. Insert the slices of bread in the toasting slot and lower the slide with the lever
until it snaps into place.
4. The appliance starts the toasting. When the set level of browning is reached,
the appliance switches off automatically. The slide pops up automatically.
Note: To make it easier to remove the toast, please lift the carriage lever slightly
(lifting function).
5. The appliance has a heat-insulated „cool-touch“ housing. The metal parts beco-
me hot during use. Leave the toaster to cool before putting it away.
To use the desired special function, press the relevant key, after pressing down the
lever:
Heating or thawing: the relevant LED indicates the function.
Thawing ( ): to thaw and toast deep-frozen bread.
Warming ( ): to warm bread already toasted.
STOP ( ): to stop toasting in advance.
Removable
toasting attachment: for the toasting of bread rolls.
Cleaning
• Pull the mains plug out of the mains socket before you clean the unit and allow
the unit to cool down.
• Only use a slightly damp cloth to clean the outside of the unit.
• Do not use abrasive or aggressive cleaners.
• Remove the crumb tray from the slot, remove the crumbs and insert the tray
again.
25
GB
