686610

Clatronic KB 3713 Manual

30
Zoom out
Zoom in
Previous page
1/56
Next page
KB3713_IM 19.11.18
30
Unpacking the Appliance
1. Remove the appliance from the package.
2. Remove all packaging material such as lms, ller, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under “Cleaning”.
Scope of Delivery
1 Cooler box
1 Power cord for alternating current (AC) 220 – 240 Volt
1 Car power cord for direct current (DC) 12 Volt
Notes for Use
General Notes
• Never place the appliance next to naked ames or other
heat sources.
• For best results, only store already cooled food / bever-
ages in the cooler. Select a place of use that is protected
from direct sunlight.
• The lid is locked when the handle is pushed back and
when carrying.
• To open the cooler box, pull the handle forward.
• Do not open the lid more often than required. Do not
leave the lid open more often than it is necessary. This
affects the cooling performance.
• The cooling duration depends on the ambient temper-
ature.
• The appliance is not suitable for permanent operation.
• The appliance can be connected to two different energy
sources.
- Alternating current: 220 – 240 V~ or
- Direct current: 12 V
• Use the switch to select an operating mode.
NORMAL or ECO?
In order to operate the appliance in energy-efcient mode,
use the setting ECO.
NOTE:
• You may only use the appliance with the function ECO
when connecting it to alternating current 220 – 240 V.
• The output is reduced in the operating mode ECO.
Use this operating mode when there are smaller loads
in the cooler box, for example.
Using the Appliance
The switch for the operating mode, the AC connection
socket and the DC cable can be found at the backside of
the appliance.
Connection to the Alternating Current
1. Check to make sure that the mains voltage that you
want to use is 220 – 240 V~.
2. Plug the power cord for alternating current into the AC
socket on the appliance.
3. Connect the appliance to a properly installed earthed
socket.
4. Set the switch to NORMAL or ECO.
Connection to the Direct Current
1. Remove the power cord for the alternating current, if
necessary.
2. Turn on the engine of the motor vehicle.
3. Remove the DC cable from the cable storage compart-
ment at the backside of the appliance.
CAUTION:
The cable is rmly connected to the appliance. You
won’t be able to remove it.
4. Connect the appliance to the cigarette lighter in the
motor vehicle.
5. Set the switch to NORMAL.
NOTE:
Protect the battery of your motor vehicle. Only run the
appliance in the motor vehicle while the engine is running.
Terminating Operation
There is no automatic shut-off. The appliance runs perma-
nently as long as it is connected to a power source.
1. Unplug the power cord from the socket or the cigarette
lighter.
2. If you have operated the appliance with alternating cur-
rent, unplug the connection cable from the appliance.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic KB 3713 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic KB 3713 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info