534819

Clatronic DR 3280 Manual

30
Zoom out
Zoom in
Previous page
1/56
Next page
ENGLISH
ENGLISH
30
Unpacking the Device
• Remove the main device and accessories from the box.
• Also remove any packaging materials that may be present.
• Check the scope of delivery.
Initial Operation
Filling up the Heating Boiler before Use!
Before the tank cap is opened it must be ensured that the device
is not under any pressure. Please proceed as follows:
1. Remove the plug from the socket.
2. Turn the lock (22) on the steam pistol (20) to ON (Fig. B1).
3. Press the steam switch (21) on the steam pistol (Fig. B2).
Point the steam nozzle at a surface which is allowed to
become wet.
ޥ NOTE:
After prolonged periods of non-use it is normal for a small
quantity of condensation to come out of the steam pistol
at fi rst.
WARNING:
• If the device is still warm after an interruption to
its use there is a danger of injury!
• Please open the safety lock (6) only when no more
steam comes out of the nozzle.
4. Turn the lock in an anticlockwise direction.
ޥ NOTE:
For your protection the safety lock has a release device.
If the pressure in the kettle is still too high, this release
device prevents it from being opened.
5. Shake any residual water out of the kettle (7). Fill freshwater
from the measuring beaker (15) into the kettle. Take care of
water splashes that might come out of the boiler. In order to
avoid water spray, please use the funnel supplied (Fig. E).
The water should be fi lled in slowly.
CAUTION:
• Do not overfi ll! Max. water capacity: 1.5 litres
• Do not use condensation from a tumble dryer (chemi-
cal residues)! This is not distilled water!
6. Retighten the safety lock (6) in a clockwise direction.
Attachment of the Individual Accessories
It is possible to attach the individual nozzles directly to the steam
pistol (20) of the hose (1):
• Attach the jet nozzle (14) to the steam pistol until it locks in
place.
• In order to release the nozzle again, please press the button
on the steam pistol.
• Keep the button pressed down and then pull the nozzle off.
Or extend the nozzle attachments with one or two extension
tubes (8):
• Please insert the sections of the 2-part extension tube one
inside the other until it locks into place (Fig. G). Then attach
it to the steam pistol (20).
• Attach the fl oor brush (18) to the extension tubes: press the
jointed adapter (17) on to the fl oor brush and turn it tightly
through 180°.
• If you would like to use the non-woven cloth, attach it to the
fl oor brush with the help of the clips (Fig. H).
• In order to release the extension tube, please press the but-
ton on the steam pistol.
ޥ NOTE:
Various attachments can only be used in conjunction with the
adapter (13). Place this on the jet nozzle (14) and fi x it in place
by turning through 90°. Please note the bolts in the adapter
and the guiding groove in the jet nozzle. Check that everything
is properly connected!
Nozzle Adapter Use
Floor brush (18) Jointed
adapter
(17)
• for large fl oor surfaces
(Fig. J)
• with non-woven cloth: for
sensitive surfaces (Fig. K)
Round brushes
(11)
Jet nozzle
(14)
with adap-
ter (13)
• for joints, fi ttings, grill grid
etc or
• for diffi cult-to-access areas
(Fig. I and L)
High-pressure
nozzle (12)
Jet nozzle
(14)
with adap-
ter (13)
• for concentrated, high
steam pressure (Fig. M)
Window wiper
(19)
Jet nozzle
(14)
with adap-
ter (13)
• for windows or shower
partitions
Jet nozzle (14) Adapter
(13)
• without attachments, e.g. for
car wheel rims (Fig. N)
WARNING: THERE IS A DANGER OF INJURY!
Never attach or remove the accessories if the steam switch
(21) is pressed in! Wait until the device has cooled down.
Electrical Connection
1. Before inserting the plug into the socket. Make sure that the
mains voltage to be used matches that of the device. You
can fi nd this information on the nameplate.
2. Connect the device to a duly installed 230V/50Hz protective
contact socket.
Connected Wattage
The station has a total maximum wattage of 1500 W.
05_DR 3280.indd 3005_DR 3280.indd 30 18.12.2008 9:28:51 Uhr18.12.2008 9:28:51 Uhr
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic DR 3280 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic DR 3280 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 4,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info