First Use of the Machine
Numbering of the Controls
1 Steam jet button 6 Control lamp
2 Steam regulator with self-clean function 7 Base
3 Filler opening for the water tank 8 Temperature regulator
4 Spray nozzle 9 Water tank
5 Spray button
• Clean the ironing base with a slightly damp cloth.
•
The water tank (9) is filled through the replenishing hole (3) with cold water. If the
water is hard, please use distilled water. Use a replenishing container if necessary.
Using the Machine
NOTE: Only clothes should to be ironed with this machine.
Ironing without Steam (Steam quantity regulator set to MIN)
1. Place the iron on its stand (7).
2. Electrical connection
Make sure that the iron voltage (see name plate) and the line voltage match.
3. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat (8):
¼ Synthetics, silk (low temperature)
¼¼ Wool (medium temperature)
¼¼¼ Cotton, linen (high temperature)
4. Insert the plug into a socket with earthing protection.
5. The control lamp (6) lights up. As soon as it shuts off, the set temperature is
reached (approximately 3 min.). Now you can start to iron.
6. Always pull the plug out of the socket after using the iron.
Steam Ironing
For this a high temperature is needed (cotton, linen). The quantity of steam can be
regulated using the steam quantity regulator (2). Extra steam can be added with the
steam jet function (1).
Vertical Steam: This can be used to produce a jet of steam in a vertical direction.
Self-Cleaning
1. Half fill the water tank with water.
2. Heat the machine up to its maximum temperature. After the control lamp (6)
goes off remove the machine from the mains supply.
3. Now hold the machine horizontally above a sink, turn the steam quantity control
(2) to the self-cleaning symbol and rock it to and fro until the tank is empty.
When pressed and turned the control switch then returns to the position.
28
GB
47497-05-DB 2546 EST 22.04.2002 11:14 Uhr Seite 28
