653928

Clatronic CL 3672 Manual

30
Zoom out
Zoom in
Previous page
1/54
Next page
30
CL3672_IM_new2 14.12.2016
Handling Batteries
WARNING:
• Do not expose batteries to excessive heat such as sunlight, re or
similar. There is a risk of explosion!
• Batteries are not toys. Keep away from children.
• Do not open batteries by force.
• Avoid contact with metal objects (rings, nails, screws, etc.). There is
a risk of short circuit!
• A short circuit could cause the battery to heat up excessively or even
to catch re, resulting in injuries.
• For your own safety, cover the battery terminals with adhesive tape
during transport.
• In case of battery leakage, make sure not to rub the liquid into your
eyes or mucous membranes. In case of contact, wash your hands
and rinse your eyes with clear water. Seek medical attention if any
discomfort persists.
CAUTION:
• When not using the remote control for a long period of time, remove
the batteries in order to prevent “leakage” of battery acid.
• Different battery types or new and used batteries must not be used
together.
• Do not dispose of batteries along with domestic waste. Return used
batteries to the relevant collection facilities or your retailer.
Overview of the Components
1 Air inlet on the side of the appliance (Filter)
2 Control panel
3 Air outlet (ns)
4 Mains cable
5 Exhaust pipe connector
6 Exhaust pipe adapter
7 Flexible exhaust pipe
8 Water outlet
9 Rear side air inlet (Filter)
10 Control lamp W.F
11 Control lamp HIGH
12 Control lamp LOW
13 Control lamp TIMER
14 Display
15 Control lamp COOL
16 Control lamp DEHUM
17 Control lamp FAN
18 TIMER button
19 SPEED button
20 MODE button
21 IR receiver for remote control
22 TEMP −   button
23 TEMP + button
24 POWER button
Delivery Scope
1 Air conditioning appliance
1 Remote control
2 Batteries
1 Flexible exhaust pipe
1 Exhaust pipe adapter (Connection on the appliance)
1 Window kit, 2-piece
1 Adapter for the window exhaust kit
1 Water hose, Ø 16 mm
2 Rubber caps (spares)
2 Plugs (spares)
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all the packaging material such as plastic bags, ller material,
cable ties and cardboard packaging.
3. Check that all parts are supplied in the package.
Notes on Use
CAUTION: Important for initial operation or after transport!
Before initial operation, the appliance must stay in an upright position for
at least 3 hours in order for the cooling agent to sink. The compressor
will be damaged otherwise.
CAUTION:
• When you interrupt the operation with the POWER button, wait for
at least 3 minutes before switching the appliance on again.
• If you want to move the appliance to another location, rst empty the
water tank!
NOTE:
You will nd all operating buttons on both the appliance and the remote
control. Same buttons represent the same functions.
• The appliance operates most effectively with a room size up to 70 m³.
• The exible exhaust hose and the adapter (6) have been manufactured
especially for this appliance. In order to avoid incorrect operation, do not
replace the pipe with another pipe.
• The exhaust pipe can be extended up to 150 cm. Do not use any
extension.
• Ensure free airow. Make sure not to kink or bend the exhaust pipe. Any
blockage can cause the appliance to overheat.
• Close all windows and doors in order to prevent outside air from
entering the room and thus allowing a more effective operation of the
appliance.
Initial Operation
Location
• When installing the appliance, make sure to keep a distance of at least
30 cm between the appliance and any walls or other objects.
• The surface must be at and dry.
Assembly of Exhaust Pipe
NOTE:
For sliding windows, you may use the window kit provided and install it
in a vertical or horizontal position. Adjust the length of the seal plate as
desired.
1. Turn the adapter (6) to one end of the exhaust pipe.
2. Connect the exhaust pipe to the appliance using the exhaust pipe
connector. Set the adapter rst on the left side. Press the adapter on
the right side down into the linkage.
3. Extend the pipe to the desired length.
4. Stick the open end of the pipe into a window.
5. Close the window as far as possible. Also lower any external roller
blinds, if present, to the end of the pipe.
Remote Control
1. Open the battery compartment cover on the back of the remote
control.
2. Insert 2 batteries of type R03 “AAA” 1.5 V, observing the correct polarity
(see markings on the bottom of the compartment)!
3. Close the battery compartment cover.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic CL 3672 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic CL 3672 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info