Manual Clatronic CL 3637 (page 30 of 50) (English, German, Dutch, French, Italian, Polish, Spanish)

653937

Zoom out

Zoom in

1/50

CL3637_IM_new 15.12.2015

Handling batteries

WARNING:

• Do not expose batteries to excessive heat such as sunlight, ﬁ re or

similar. There is a risk of explosion!

• Batteries are not toys. Keep away from children.

• Do not open batteries by force.

• Avoid contact with metal objects (rings, nails, screws, etc.). There is a

risk of short circuit!

• A short circuit could cause the battery to heat up excessively or even

to catch ﬁ re, resulting in injuries.

• For your own safety, cover the battery terminals with adhesive tape

during transport.

• In case of battery leakage, make sure not to rub the liquid into your

eyes or mucous membranes. In case of contact, wash your hands

and rinse your eyes with clear water. Seek medical attention if any

discomfort persists.

CAUTION:

• When not using the remote control for a long period of time, remove

the batteries in order to prevent “leakage” of battery acid.

• Different battery types or new and used batteries must not be used

together.

• Do not dispose of batteries along with domestic waste. Return used

batteries to the relevant collection facilities or your retailer.

Overview of the Components

1 Air inlet on the side of the appliance (Filter)

2 Control panel

3 Mains cable

4 Air outlet (ﬁ ns)

5 Exhaust pipe connector

6 Rear side air inlet (Filter)

7 Exhaust pipe adapter

8 Flexible exhaust pipe

9 Water outlet

10 POWER button

11 TEMP + button

12 TEMP − button

13 IR receiver for remote control

14 Display

15 MODE button

16 SPEED button

17 TIMER button

18 LED WATER FULL

Supplied parts

1 Air conditioning unit

1 Remote control

2 Batteries

1 Flexible exhaust pipe

1 Exhaust pipe adapter (Connection on the appliance)

1 Window kit, 3-piece

1 Water hose, Ø 10 mm

2 Rubber caps (spares)

2 Plugs (spares)

Unpacking the appliance

1. Remove the appliance from its packaging.

2. Remove all the packaging material such as plastic bags, ﬁ ller material,

cable ties and cardboard packaging.

3. Check that all parts are supplied in the package.

Notes on use

CAUTION: Important for initial operation or after transport!

Before initial operation, the unit must stay in an upright position for at

least 3 hours in order for the cooling agent to sink. The compressor will

be damaged otherwise.

CAUTION:

When you interrupt the operation with the POWER button, wait for at

least 3 minutes before switching the appliance on again.

NOTE:

You will ﬁ nd all operating buttons on both the unit and the remote con-

trol. Same buttons represent the same functions.

• The appliance operates most effectively with a room size up to 70 m³.

• The ﬂ exible exhaust hose and the adapter (7) have been manufactured

especially for this appliance. In order to avoid incorrect operation, do not

replace the pipe with another pipe.

• The exhaust pipe can be extended up to 150 cm. Do not use any

extension.

• Ensure free airﬂ ow. Make sure not to kink or bend the exhaust pipe. Any

blockage can cause the unit to overheat.

• Close all windows and doors in order to prevent outside air from enter-

ing the room and thus allowing a more effective operation of the device.

Initial operation

Location

• When installing the device, make sure to keep a distance of at least

30 cm between the unit and any walls or other objects.

• The surface must be ﬂ at and dry.

Assembly of exhaust pipe

NOTE:

For sliding windows, you may use the window kit provided and install it

in a vertical or horizontal position. Adjust the length of the seal plate as

desired.

1. Turn the adapter (7) to one end of the exhaust pipe.

2. Connect the exhaust pipe to the unit using the exhaust pipe connector.

Set the adapter ﬁ rst on the left side. Press the adapter on the right side

down into the linkage.

3. Extend the pipe to the desired length.

4. Stick the open end of the pipe into a window.

5. Close the window as far as possible. Also lower any external roller

blinds, if present, to the end of the pipe.

Remote control

1. Open the battery compartment cover on the back of the remote

control.

2. Insert 2 batteries of type R03 “AAA” 1.5 V, observing the correct polari-

ty (see markings on the bottom of the compartment)!

3. Close the battery compartment cover.

Mains connection

1. Make sure the mains voltage you want to use corresponds to the volt-

age of the unit. Please check the rating label for detailed speciﬁ cations.

2. Connect the unit to a properly installed grounded socket. A signal will

sound indicating that the unit is ready for use. The display will show the

current room temperature with low illumination.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic CL 3637 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,94 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Clatronic CL 3637 Manual

Product: