319569
36
Zoom out
Zoom in
Previous page
1/64
Next page
Winding:
Press the cable
(5)
winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Accessory Compartment (13):
Pull open the lid of the accessory compartment to access the integrated accesso-
ries (upholstery nozzle, crevice nozzle/brush nozzle). Take out the nozzle you requi-
re:
Nozzle accessories:
Crevice nozzle/Brush nozzle: To vacuum corners and slits
"2-in-1" nozzle: When this is folded together (as sto-
red in the compartment) it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull
the brush section in the direction of the arrow until it
locks in place.
Upholstery nozzle: To clean upholstery, curtains, etc.
Floor nozzle: To clean carpets or smooth surfaces.
Releasing the accessories: Pull these off while turning slightly.
Air Slide:
Open the air slide on the handle of the hose to regulate the air supply or to clear off
any particles sticking to the nozzle.
Dust bag replacement display (6):
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag:
Remove the mains plug from the socket. Then open the lid of the dust bag com-
partment (10) by pressing the button (9). Remove the bag holder, press the button
with the spring together in order to release the bag and then pull the dust bag out
of holder. Press the button again and fix a new bag in place. Re-insert the bag hol-
der and then close the lid so that its locks in place.
Filter: Your appliance has two filters.
Motor protection filter (inlet filter):
The inlet filter is located in the dust bag compartment. The filter is located vertically
in the rear section of the dust housing. Remove the filter by pulling upwards. Clean
the engine protection filter after 10 dust bag changes. If necessary, the filter can
also be washed in warm water without any additives. Place it back into place only
once it is completely dry!
36
GB
5....-05-BS 1230 04.03.2003 11:29 Uhr Seite 36
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic bs 1230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic bs 1230 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info