653866
38
Zoom out
Zoom in
Previous page
1/62
Next page
38
BQS3508_IM_new 18.10.16
3.
NOTE:
There is a hole in the leg sections.
Check whether all leg sections are in the correct position
and that the holes are exposed.
4. With the help of the supplied nuts and bolts, fasten the
framework.
5. Insert the offset screws into the holes from the inside and
turn on the wing nuts.
6. Place the grill onto the framework and carefully push it on.
The grill can be pushed onto the framework to a depth of
about 2 cm.
7. Check that the stand is stable.
Installation
Stand or table top grill
Please refer to the illustrations.
1. Pour 1 litre of cold water into the grill pan up to the “MAX”
mark. A “MAX” mark can be found on the back section of
the grill pan.
CAUTION:
Always grill with water to avoid overheating.
Do not ll with water above the “MAX” mark in order
not the damage the heating element.
2. Fit the heating element with the thermostat onto the hous-
ing. Slide the thermostat from above into the recess of the
housing. Press gently until it audibly clicks into place.
3. If required, t the windshield.
NOTE:
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
Check that the thermostat is properly tted in the housing.
Electric Connection
1. Be sure the voltage of the device (rating plate) is in
accordance with the mains voltage.
2. Connect the mains plug to a properly installed shockproof
socket only.
Connected Load
The device is intended for a maximum power intake of
2000 W. This connected load recommends a separate input
lead secured with a 16 amp protected switch.
CAUTION: Overload!
When using extension cords, these should have a cable
cross-section of at least 1.5 mm².
Do not use gang plugs, because the device is too
powerful.
Prior First-Time Operation
Operate the device without barbecue for 15 minutes whilst
grill pan is lled with water.
Turn the temperature control on the thermostat to the highest
position.
NOTE:
The protective foil on the heating element will be removed.
Slight formation of smoke is thereby normal. Ensure
sufcient ventilation.
Your appliance is now ready for use.
Operating the Device
CAUTION:
The appliance must always rest on a horizontal, stable, and
heat resistant surface during use.
1. Pour 1 litre of cold water into the grill pan up to the “MAX”
mark.
2. Preheat the operable device for about 5 minutes prior use.
3. Set the temperature control according to the intended use:
Low or middle settings for keeping warm or cooking,
highest setting for fast cooking or barbecuing. The indica-
tor light indicates the operation of the heating.
4. Place your grill items directly on the grid. Turn the barbe-
cue from time to time.
CAUTION:
Check the water level!
After grilling for a long period, the water must be re-
plenished.
First disconnect from the mains and then ll with water
up to the “MAX” mark.
Do not pour cold water over the hot heating element. It
might get damaged.
End of Operation
Turn the temperature control anti-clockwise as far as it will go
and unplug the device.
Troubleshooting
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
If the heater cannot be switched on, check the mains outlet
and that the thermostat has been correctly tted into the
housing.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic BQS 3508 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic BQS 3508 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 4,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info