63042
65
Zoom out
Zoom in
Previous page
1/120
Next page
65
Removing the unit
a. Frame
b. Insert fingers into the groove in the front of frame
and pull out to remove the frame. (When re-
attaching the frame, point the side with a groove
down wards and attach it.)
c. Insert the levers supplied with the unit into the
grooves at both sides of the unit as shown in fig-
ure until they click. Pulling the levers makes it
possible to remove the unit from the dashboard.
Trim Plate Installation:
Push the trim plate against the chassis until it is fitted.
You must do this before you install the front panel, otherwise it can't be attached.
DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
1. Select a position where the screw holes of the
bracket and the screw ligned (are fitted) and
tighten the screws at 2 places on each side.
2. Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note: the mounting box, outer trim ring, and half-
sleeve are not used for method B installation.
Due to the different vehicle types and/or vehicle manufactures, a correct configuration of the ISO
plug is not ensured; even if the ISO plug connections fir mechanically one on the other.
Therefore at some reasons it could be necessery to change and/or to use motorcar-specific adapters.
During correct connection the radio can be switches on and/or off over the ignition. With possible loss of the
stored transmitters the radio does not receive “constant current connection (B+)” that is necessary for trans-
mitter storage.
CAUTION: During a connection at „constant current connection (B+)“ without ignition, for all that the
radio is switched off, an unnecessary load of the car batterie is possible. In the worst case it can cause the
unloading of the car batterie.
With Bluetooth radios it is absolutely neseccary to mind a correct connection over the ignition. Oth-
erwise there is no correct seperation of radio link between radio and mobile phone.
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic AR 760 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic AR 760 in the language / languages: English, German as an attachment in your email.

The manual is 10,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info