402264
23
Zoom out
Zoom in
Previous page
1/41
Next page
Charging the Battery
1. Connect the charging device to a 230 volt, 50 hertz socket.
2. Attach the motor housing to the charging pin.
Using the Device
1. Push a brush on to the drive rod. The bristles must point in the direction of the
switch. It must not be possible to turn the brush shaft in this position. The brus-
hes are fitted with different coloured rings so that they can be distinguished from
one another.
2. Rinse out your mouth thoroughly and moisten the bristles. You can use toothpa-
ste if required. In order to avoid splashes, switch the toothbrush on and off while
it is in the mouth.
3. Switch the toothbrush on by the switch (6).
4. Move the brush slowly in small circular movements and with a slight pressure
from tooth to tooth. It is not necessary to press hard. Take care that the head of
the brush also reaches the spaces between the teeth.
5. Rinse your mouth out after use. Pull off the head of the brush and clean it with
water. The brush head can be replaced in the container for storage.
6. The toothbrush is switched off by pressing the switch (6) again.
Note: During the first days of use it may be that bleeding of the gums occurs. This
normally stops after a few days. If the bleeding of the gums does not stop after 2
weeks, please consult a dentist.
Cleaning and Care
Pull down the brush head. Do not push down the brush but only the lower part
of the accessory (colored marking) and clean it under running water! Do not
use any additives to clean the head of the brush!
The toothbrush is watertight and can be cleaned under running water! Please
do not immerse completely in water.
Do not use any abrasive substances for cleaning! These may damage the seals
and the housing!
Simple soapy water may be used to clean the toothbrush.
Please note that toothbrushes lose their cleaning capacity after approx. 8
weeks. The spare brushes for your electrical toothbrush can be ordered at the
telephone specified in the „Service“ section.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
23
GB
4....-05-EZ 2693 11.06.2002 8:55 Uhr Seite 23
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic 271 461 refill for ez 2693 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic 271 461 refill for ez 2693 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Spanish as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info