497709

Clarke-tech V4000 VBOX DiSEqC Positioner Manual

9
Zoom out
Zoom in
Previous page
1/12
Next page
Recall saved satellite position:
With the following procedure, you can move the dish to any stored position.
1. Using the number keys on the remote, enter the satellite position shown above,
or one that you have programmed in; or
2. Press the or
keys to choose the satellite position. The display will show
the number and name of the new position. After setting the position name, the
display will flash the number and name of the position.
3. Press OK key to confirm. The actuator will move to the stored position and the
display will show the position name and number. If the position has a set
name and number, the display will show the name of the position. If the
position has only a number, the display will show the number in the position
you choose.
PS: Once you choose a satellite and the actuator is moving, you can press any key on
the remote to immediately stop the actuator.
Re-synchronize all the Satellite Positions:
In case the positions are not correct or the picture is not clear on any
satellite, the shift (re-sync) function can correct all the positions
simultaneously.
1. Use the RECALL operation to move the actuator or H-H mount to a
stored position (for example, “NSS” and “P03”) as a reference position
for “re-sync” operation.
2. Press and hold the Resync key for more than 5 seconds. The LED will
flash RESYNC and the name or number of the position.
3. Press 3
33
3MANUAL4
44
4 to fine-tune the actuator or H-H mount to get the
strongest signal.
4. Press the OK key to confirm the operation. The display will show the
name or “PXX” again (for example “NSS” and “P03”). The rest of the
satellite positions in memory will also be fine-tuned. The following
drawing shows the operation.
Imported and distributed by satmedia GmbH Germany www.satmedia.com
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clarke-tech V4000 VBOX DiSEqC Positioner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clarke-tech V4000 VBOX DiSEqC Positioner in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info