497709

Clarke-tech V4000 VBOX DiSEqC Positioner Manual

6
Zoom out
Zoom in
Previous page
1/12
Next page
Operation as Standalone Positioner
Setting the software high/low limits:
There are hardware limit switches in the actuators or H-H mounts to prevent the
mechanism from being damaged by obstacles. We still recommend that you set the
software limits for backup protection, although you can use the positioner without
setting the limits.
1. Move the actuator by pressing the 3
33
3 4
44
4 buttons on the remote to the positions you
intend to set as lower/higher (or East/ West) limits.
If you move the dish to a higher position with the 3
33
3 button, the High Limit will be set. If
you move the dish to a lower position with the 4
44
4 button, the Low Limit will be set.
2. To set the low/high (or East/West limit), press the Limit key for 2 seconds. The
display will flash LIMITL. Press the Limit button again to switch the display to LIMITH.
3. Press the OK button after the right limit display (LIMITL or LIMITH) appears. When
the set up is successful, the display will show “|-- -- -- -- -- --” (High Limit) or “-- -- -- -- --
--| “(Low Limit) to confirm the setting.
After you have programmed the travel limits and the actuator or the H-H mount moves
to its higher or lower limit, it will stop moving and the display will show “|-- -- -- -- -- --” or
“-- -- -- -- -- --|”.
Caution: Wrong limit settings, such as reversing HL and LL, may block the actuator or
H-H mount. If this situation occurs, conduct the “Clear Limit” operation then re-set the
correct limits again.
Clearing the software high/low limits:
Press the Limit key on the remote for 10 seconds. The display will show 10, 9 … 1, |--
-- -- -- -- --| then the limits setting will be cleared.
Imported and distributed by satmedia GmbH Germany www.satmedia.com
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clarke-tech V4000 VBOX DiSEqC Positioner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clarke-tech V4000 VBOX DiSEqC Positioner in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info