15
English
14
6.1 Getting Started
3) Satellite Scan
<Figure 6.1.4> <Figure 6.1.5>
Through this function, the receiver searches for all the available channels and saves them in
memory. Chose Auto Scan to search using transponders (frequencies) in memory, or chose
Blind Scan to look for new satellite/transponders.
Ȟ
Auto Scan <Figure 6.1.4>
͈
To select more than one satellite, press the RED button when the selection bar is
positioned on the satellite.
͉
Press on the names of the satellites that you want to scan under ‘Satellite List’.
Press the EXIT button to close the ‘Satellite List’.
͊
Press / and set the ‘Search Type’ and ‘Network Search’ parameters.
- Search Type : Decide for which channels to search (All channels/ Free channels only/
TV channels only).
- Network Search : Set ON to find more transponders (frequencies) through a Network
Information Table (NIT) scan. That is, when the broadcaster is
sending a NIT through a given transponder, the receiver will also scan
for transponders listed in the NIT and not otherwise recognized.
(this can happen when a transponder is new)
͋ Press under ‘SCAN’ to scan the selected satellites. <Figure 6.1.5>
6.1 Getting Started
Ȟ
Blind Scan <Figure 6.1.6>
͈
Select the satellite you want to search by pressing / buttons on the remote.
You can select more satellites by pressing RED button on the remote.
͉
Select the options by pressing / / buttons on the remote.
- Polarization : Select ALL / Vertical / Horizontal
- Scan Mode : Select ALL / FREE / TV
͊
Press button on the remote to begin blind scan of all of the satellite in the satellite list.
