580790
24
Zoom out
Zoom in
Previous page
1/35
Next page
CAUTION
Do not open the case. There are no serviceable parts inside.
If you drop anything into the unit during installation, consult
with your Clarion Dealer or an authorized Clarion service
center.
Mounting and wiring precautions
The OHM888VD / OHM1088VD / OHM1588VD should be mounted in the ceiling of the
vehicle. The front panel controls should be easily accessible from the rear seat. In addition:
y This unit is exclusively for vehicles with a negative ground, 12V power supply.
y This unit may be in installed with additional mobile audio components, such as a digital
camera.
y Always use great care when attaching anything to a vehicle! Check clearances on both
sides of the planned installation before drilling any holes or installing any screws.
y A good chassis ground connection is critical to minimize resistance and avoid noise
problems. Use the shortest wire possible and securely connect it to the car chassis and
the source unit ground.
y When routing RCA cables, keep them away from the power cables and output speaker
wires, engine, exhaust system, etc. Heat may damage wires.
y If the fuse should blow, make sure that all connections are correct, the cables have not
caused a short circuit, and no wires are damaged. Then replace the fuse with a new
fuse of the same amperage value as the original fuse. When replacing a fuse, never let
the battery side touch any metal part or any other wire.
y Never let disconnected cables or terminals touch metal on the car or any other
conducting material.
y To prevent short circuits, do not remove the caps from unused terminals or from the
ends of unconnected cables.
y Insulate unconnected wires with vinyl tape or other similar material.
WARNING!
To prevent short circuits during installation, disconnect the
vehicle’s negative (-) battery lead before making any power
connections.
Installation procedure
The OHM888VD / OHM1088VD / OHM1588VD replace the car’s dome light. This section
provides basic tips and techniques to aid the installation. These are not vehicle specific, but
should be used as guidelines for performing the installation.
Set the polarity switch
1. Determine the polarity of the power system in the car. This information should be on a
vehicle-specific diagram.
2. Locate the polarity switch on the back of the player (the side that will be attached to the
ceiling).
OHM888VD / OHM1088VD / OHM1588VD 24
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clarion OHM888VD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clarion OHM888VD in the language / languages: English as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Clarion OHM888VD

Clarion OHM888VD User Manual - German - 37 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info