4.3. Satellite
The satellite ASTRA is set at the factory. The other 7 satellites, e.g. Hotbird, are pre-programmed. For
extending your receiving system, you can make the required settings for the 7 pre-programmed
satellites in the ‚Satellite‘ menu.
Activate the desired satellite number, e.g. with the numerical buttons [1...8], and call up the entry menu
with the [OK] button.
(1) Entering or changing the name
Activate the entry field {NAME} with the [1] button, and then activate the field with the [OK] button.
With the [▼] or [▲] button, you can select the letters (capitalised a. small) or digits.
With the [►] or [◄] button, you can move the entry position to the right or to the left.
After entering the desired name, the entry field is deactivated by pressing the [OK] button again.
(2) Enter in LO1
(3) Enter in LO2
LO1 a. LO2 are pre-set to 9750 MHz a. 10600 MHz at the factory.
If the LNB LO frequencies deviate from the pre-set values, you must enter in the appropriate values
here. Activate the field with [OK] and enter in the LO frequencies with the numerical buttons
[0].....[9]. Then, end the entry by pressing [OK].
Please make sure, that a ‚digital‘ compatible LNB is integrated in your receiving system.
(4) Enter in the orbit position
The parameter „Orbit position“, possible values 1...4, must be given for controlling the DiSEqC.
(5) Release
{ON} The selected satellite is released for your receiving system.
{OFF} The selected satellite is locked.
4.4. Installation
4.4.1. Time offset
After switching the unit on via the mains switch or after a power failure, the time and date for the timer is
taken from the received data. In order for the time and date of the receiver to comply with the current
local time, the deviation from the normal time must be given.
The offset for the UTC summer time is {+ 2} hours and for the UTC winter time is {+ 1} hour.
Please check or correct the time offset for initial operation and then for the time change in
spring and fall.
(1) Call this up with the digit [1] or with the [▼] [▲] buttons. Then, activate it with the [OK] button, and
set the desired time difference with the [►] [◄] buttons. The change is completed by pressing the
[OK] button.
Note: When the time offset is wrong, the programme times will be incorrectly displayed.
- 15 -
