556055
36
Zoom out
Zoom in
Previous page
1/37
Next page
— 33 —
a. The ERROR and PE LED indicators are provided with a resistance of 330 W in
the circuit to keep the current value at 10 mA. To use this terminal, adopt an
LED rated with about 2V of forward voltage. If you use an LED exceeding 10
mA, the control board may be destructed.
b. For the power supply for driving mechanism (pins 7 through 12) at the power
terminals and GND (pins 13 through 18), supply power to all the pins to keep
the capacity.
*GND of pins 4 through 6 shall be used for grounding the interface or the
like. If unnecessary, common use of GND for pins 13 through 18 is
recommended.
c. The serial interface is equipped with RS-232C driver and receiver. Be sure to
use it at RS-232C level.
d. The RESET terminal (pin 39) is pulled up with 3.3 kW. If this terminal is not
used, set it to NC.
e. Either serial interface or parallel interface is usable.
* You can use either one of the interfaces and cannot use both at the same
time.
f. The attached cable is about 300 mm in length. Adjust the length as necessary.
However, avoid excessive extension of wiring. Otherwise, printer malfunction
may result due to noise, etc.
*In consideration of the effect by noise, etc., unused wiring requires some
treatment such as cutting from the root.
g. As pin 19 is used inside of the printer, Never connect it to the opposite
equipment.
CAUTION!
Wrong wiring may cause trouble not only on the printer but also on the opposite
equipment connected.
5.5
Specifications of Connector for USB Interface
USB miniB type
12345
Pin No.
1
2
3
4
5
VBus+5V
-DataD-
+DataD+
NC
GND
Name
NC:FNone Connect
CAUTION!
The USB interface is a factory-set option. It is not installed in the standard printer.
Purchase your USB cable by confirming the connector type.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Citizen CT-P290 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Citizen CT-P290 in the language / languages: English as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info