556053
15
Zoom out
Zoom in
Previous page
1/58
Next page
— 12 —
3.2 Part Descriptions
(1) I/F connector Printer can be connected to the signal line of various kinds
of host via a cable. Please ensure that both the printer and
the host are turned off before connecting or disconnecting.
This connector also has a power input.
Connect the FG terminal to the earth.
Cable connected differs with the interface.
(2) FEED switch Paper is fed while this switch is pressed and held.
Turning the printer power on while pressing and holding
this switch causes self-printing to start.
In the memory switch setting mode, various kinds of setting
are available by pressing this switch.
(3) Power lamp Lights/blinks when the paper has become scarce or run out.
The lighting status depends on the memory switch setting.
Blinks when mechanism error or the like occurs depending
on the condition of memory switch setting.
(4) Knob Used to set paper or to open the front cover when setting
or replacing paper.
(5) Ribbon cover Opened/closed when replacing the ink ribbon cassette. Can
open when you pull the left side of the front face toward
you.
(6) Paper holder Printing paper is set and fixed here.
Insert the print paper into the paper inlet and then set the
paper.
(7) PE sensor Detects no paper condition.
(8) PNE sensor Detects paper-low condition.
This function is enabled or disabled depending on the mode
or memory switch setting.
(9) DIP switch (SW1) This switch allows basic initial setting.
Use this switch before turning on the printer.
(10) Back switch Press this switch to use special function.
This switch is not used in normal operation.
(11) POWER lamp Lighted when power is turned ON. Blinks at the occurrence
of error or during memory switch setting.
(12) Mounting bracket A bracket to hold the printer body.
Hold the printer to the panel or the like by using the two
screws supplied.
(
Interface connector
)
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Citizen CBM-920II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Citizen CBM-920II in the language / languages: English as an attachment in your email.

The manual is 0,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info